Jump to content
SAU Community

Recommended Posts

Hey every,

i've done 5,000km since my rebuild...

having a dyno done i only recieved 155 RWHP @ 4500rpm... stopped it early due to fuel pump was dead!!

dyno gave me a reading of heading to 16:1 AFR near 5k RPM

lucky i got forgies in caught it early.. so it wouldnt kill this engine toooo!!

and yeah what made me take it in... is coz it made no power at all, culdnt spin the wheels or jack!

so i got this bosch 040 pump fitted, drove away and she throw me side ways 1st, 2nd n nearly 3rd!

problem is, i can be gunning it... hit the limiter hard 'for like 5secs' n then change gears n it major backfires

n then sounds to missfiring 'WRX sound ' ? or is it over fueling on the limiter coz the inigition??

i got new spitfire coilpacks aswell!!

so yeah anyways i took her for a ride last nite, was going good.. n then took off from the lights n not much power again.. like the fuel pump

problem..?!?!

thinking it was the CRAP GFB manual el-cheapo boost controller i drilled the whole out abit... erm seemed to lower my boost n fkn seems to take ages to spool up now! n the car just makes heaps of noise n speed doesnt go around as shabby as it did n does sometimes!!

WTB my old engine power back =(

any1 had simarly troubles? or any ideas?

should i get ECU? over fueling now? =(

Edited by Mr_GaZZa
Link to comment
https://www.sau.com.au/forums/topic/206499-gts-t/
Share on other sites

hey mate,

thanks for the reply... i fort it could be to much fuel now.. stock injectors but ?!

yeah got a boost gauge, its about 10PSI.

until i drilled out the manual boost controller hole a lil n dropped it abit, now takes a while to boost up.

any1 else can confirm its running to rich maybe..

if so i'll get a ecu and a tune!

Thanks

Link to comment
https://www.sau.com.au/forums/topic/206499-gts-t/#findComment-3653001
Share on other sites

get another cheap boost controller and don't drill shit.

what is the drilling supposed to do?

what exactly did you drill?

:thumbsup:

hey guys..

driving to work dismorning, after screwing down the key in the manual boost controller a fair bit...

aftermarket boost gauge shows 9-10psi,

coz yestaday arvo i was loosened it majorly... coz i drilled the small hole that flows into the controler 'IN SIDE'

only a drill-bit that was a little bigger in diameter... thinking that may of cause my problems cause i

'read the manual, and said it can cause wierd crap 'surging' n you might need to make it a little larger in diameter 'so i did'.

but driving to work dismorning, i received lots of power, no lag or delay. didnt even surge!!

think i need a ECU to fine tune this mo-foe

any1 have any comments on Greddy E manage units?

and wheres can i get this tuned in PERTH??

BTW mods are as below;

FORGED Melie Pistons/Shells n Gaskets Spitfire Coilpacks Stock Camshafts Boosted to 10PSI bosch 040 Fuel pump Front Mount Intercooler GFB Boost Controller HKS replica SSQ BOV HKS Super Flower Pod Fliter HSD Full Adjustable coilovers HKS replica SSQ BOV 3 n 1/2" Stainless Cat Back With 7 n 1/2 Stainless Inch Muffler Twin Plate H/duty Clutch

Link to comment
https://www.sau.com.au/forums/topic/206499-gts-t/#findComment-3653420
Share on other sites

Wat tha?

well theres only a few ways to determine if your car is running okay.

1. just never give it any and then you wont find any major fueling/boost or inigition problems

2. take it out and give it a bit and fault find < against componets and search for possiable causes

3. waste money on dynos, and pay for them to guess and point their finger at things.

the only real way i you can personally feel/find a difference in performance, is drive it

in different conditions... OMG?!

and by the way... i treat my car and engine probably alot better then most others on here.

serviced every 5,000km oil and filter. gets all new geniue parts or aftermarket

equilient or better! only use 98RON BP fuel also!!

gets full clean / wax / polish every weekend.

but yeah, away from that? anyone rekon ECU / AFM meter cant handle it?

and anyone got any experience with the GREDDY E MANAGE?

P.S sorry about the spelling... will try and improve on!

*ADDED*

PROBLEM - SURGING / JUST REVING N ALL NOISE?!

uses major fuel when under-load...

ECU? CAS? AFM?

Edited by Mr_GaZZa
Link to comment
https://www.sau.com.au/forums/topic/206499-gts-t/#findComment-3653735
Share on other sites

just leting you know that doing this will reduce the life of your engine by a significant amount.

Hey homeboy!!

did you miss this?

FORGED Melie Pistons/Shells n Gaskets Spitfire Coilpacks Stock Camshafts Boosted to 10PSI bosch 040 Fuel pump Front Mount Intercooler GFB Boost Controller HKS replica SSQ BOV HKS Super Flower Pod Fliter HSD Full Adjustable coilovers HKS replica SSQ BOV 3 n 1/2" Stainless Cat Back With 7 n 1/2 Stainless Inch Muffler Twin Plate H/duty Clutch

Surely this is the problem!! :whistling:

Link to comment
https://www.sau.com.au/forums/topic/206499-gts-t/#findComment-3653802
Share on other sites

i treat my car and engine probably alot better then most others on here.

serviced every 5,000km oil and filter. gets all new geniue parts or aftermarket

equilient or better! only use 98RON BP fuel also!!

gets full clean / wax / polish every weekend.

Well at least it will look nice and pretty on the back of a tow truck..

I don't call lots of mods and no form of engine management "treating my car well"

Link to comment
https://www.sau.com.au/forums/topic/206499-gts-t/#findComment-3653820
Share on other sites

omg guys... its not like i sit on rev limiter?? !!!

=/ SIGH... i think you've totaly missing the point of what happens, just someone told me its over fueling..

and by the way, limiter is there to stop u doing damage LOL if your not riding it all day 'drifting' ect

awww u rekon its the ATMO BOV..

haha it stalls it time to time, but seriously? was more so thinking ECU...

thanks GTST

will try stocker 2nite

Link to comment
https://www.sau.com.au/forums/topic/206499-gts-t/#findComment-3653847
Share on other sites

and by the way, limiter is there to stop u doing damage LOL if your not riding it all day 'drifting' ect

No the limiter is to protect the car from knobbos who dont know when to change gear.. It still does damage.. just not as much as over revving

Edited by MotoMan
Link to comment
https://www.sau.com.au/forums/topic/206499-gts-t/#findComment-3653853
Share on other sites

Well at least it will look nice and pretty on the back of a tow truck..

I don't call lots of mods and no form of engine management "treating my car well"

wooohooo

okay? so now its ECU and not treating my car right... by running a lil 2-3psi increase with

fuel and stock ecu? no one told me thats abusing a RB25DET?

kk thanks for the advice, i'll take that as + 1 for getting a new ecu

P.S mate my skyline wont be on a tow truck... =/ scarcasim much here?

Link to comment
https://www.sau.com.au/forums/topic/206499-gts-t/#findComment-3653869
Share on other sites

2-3psi increase..

BOV

3 1/2 catback with 7 1/2 tip

FMIC

more than enough to make your car run like crap..

And i certainly wouldnt be doing any regular rev limiter action without some form of engine management

p.s. No sarcasm.. i honestly think you are a knob

Edited by MotoMan
Link to comment
https://www.sau.com.au/forums/topic/206499-gts-t/#findComment-3653877
Share on other sites

ok thanks motoman,

i see where your coming from, maybe i've described my problem badly / limiter.. k n 5secs is prob more so 1s!!

i thinks i need some sort of ECU too

extra fuel and air... maybe it cant handle it, hence when shift backfires?

any1 reccomend E-manage ultimate?

Link to comment
https://www.sau.com.au/forums/topic/206499-gts-t/#findComment-3653901
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Latest Posts

    • Yep, that was one of the things we learned fast in the past with our MX5. When you drive with the top down, you are effectively standing out in the sun, 100% of the time, and not getting in any shade (because roads aren't shaded generally!). Just like standing out in the middle of a field on a sunny 27C day is a bit of a bad plan, so is sitting in a MX5 without sun protection.
    • I also just ordered some Frankenstein bolts and side mounts to fit a hard top Just in case I do find one, basically so it doesn't need to be fixed to the car with only the front latch.......and then gaffa tape to keep it in place for the RTN journey from wherever I get it
    • If your temps are fine now, you probably won't have any issues with where your vents are as they don't look right up at the windscreens high pressure area, so any differences when giving it the beans for extended happy laps would be minimal, but, they should vent heaps when stuck in traffic  Much like how that reverse cowl on my SS let "visible" heat out when stationary, but, because it was basically at the windscreen my coolant temps on the Hwy actually raised because air was being fed into it at speed (110kph), to only come back down to around 90° when I got off the Hwy And your 100% correct about the NC currently not needing vents, but, if I was to add a turbo, and a oil cooler and intercooler in front of the condenserand radiator, and then take it to the track???? It is apparently a recommend requirement if I don't want to worry about coolant or oil temp issues, but, any of the above are possible scenarios, over time As it sits now, with the triple pass radiator and stock air conditioning system, I have absolutely no issues with either temps or air conditioning efficiency, I've been basically daily driving thie car for the last month, both on the Hwy, and peak hour, bumper to bumper traffic, but, that's pretty much expected from basically a standard engine  Talking about no issues daily driving, it was 39° the other day and I was sitting in bumper to bumper traffic on the M5 and then M7, with the top down, and with the air conditioning blowing nice cold air on my feet, balls, and face, well, there was one issue, my head and arms got pretty sun burnt Note to self: leave a hat and sunscreen in the car for such days 🤣
    • I would agree, unless you need something specific to the HV motor/battery side repaired or investigated, any mechanic will be able to perform normal services, but if you prefer, maybe look for a mechanic who regularly services/repairs Nissans, the VQ engines are pretty common in the Nissan lineup.  Sorry, I can't make any suggestions, I don't live in Vic.
    • Some of them keep working fine. 9 out of 10 of them end up causing an absolute misery bleeding the system and get thrown on the workshop floor in a tantrum and never thought about again because they were never really needed and just added crap to the car that we could have done without. Same-same with HICAS, A-LSD, and various other stupidities that over eager 10x engineers thought we had to have.
×
×
  • Create New...