Jump to content
SAU Community

Recommended Posts

Hi all,

Item: Standard turbo of rb20

Location: Gold Coast

Website: here

Item Condition: vgc

Reason for Selling: upgrading to new one/bigger one

Price and Payment Conditions: $200 - cash

Extra Info: Im upgrading my turbo therefore the

standard rb20 turbo is up for sale.

The turbo is still hooked up on the car

so it can be heard/driven/seen/inspected etc...

its done 120,000km, and has been used with 10psi

through it for the last 40,000km (since ive had it).

hasent been thrashed, and is in great condition,

as mentioned - inspections more than welcome.

Can deliver locally (to be discussed)

Contact Details: contact via thread/pm/or moblie - 0414 949 851

Cheers

Peter

:banana:

Link to comment
https://www.sau.com.au/forums/topic/206576-1-x-turbo/
Share on other sites

  • 3 weeks later...
  • 4 weeks later...
  • 4 weeks later...
  • 1 month later...


  • Similar Content

  • Latest Posts

    • Haha yea it's a bit of a weird setup at the moment, just wanted to make sure I sorted out any headaches before dyno day. At the moment I've changed the exhaust manifold, turbo and downpipe, 460lph fuel pump and rising rate reg as well as the previously mentioned headstuds and gasket. The nistune was already mapped for the car as it was and drove around for a few months no worries. The plan is to run flex fuel hence the big pump, which I've wired direct to the battery through a relay to avoid voltage issues.
    • Um. Was the ECU the same as the one previously there? I know R33's needed R32 GTST ECU's or other tomfoolery to run Nistune. This is such a wild setup. Most people would plumb in the turbo then not drive the car (i.e tow it to a tuner). What's actually changed since it last ran?
    • I'm a bit stuck with this one fellas, I recently decided to undertake a turbo conversion on my GTS-4, ended up pulling the motor to replace all the seals and do an mls head gasket and arp head studs while I was at it. Everything has gone according to plan, no oil or coolant leaks, compression checked out, and decided to give it a test before I book it in for a tune As it stands right now, the turbo only has oil lines plumbed so that I don't put boost into my untuned engine, and I'm using the factory GTS-T crossover pipe with a maf and poddy as a temporary intake. The car starts with relative ease and idles amazingly, however as the title suggests it really doesn't want to rev up, runs very smooth but almost feels choked out and unresponsive to the throttle, almost like it's running lean or something? I've triple checked my vacuum lines and timing with a timing light, injectors haven't been touched as of yet to avoid flooding the engine and worked perfectly beforehand, new plugs and coilpacks, I've even unbolted the cat just to see if it spontaneously collapsed, no dice The car currently has a nistune r32 gtst ecu installed so I have no way to check for fault codes. At this point I'm a bit stumped. Is this normal behaviour for a car with a turbo bolted onto the exhaust going nowhere? I'd imagine the turbo wouldn't cause this much restriction in the exhaust without the boost going through the intake. Any ideas? If necessary I can link a video of how it responds to full throttle while in neutral.  
    • Insert tab A into slot B?
    • Instructions seem simple enough to understand.....
×
×
  • Create New...