Jump to content
SAU Community

Bad Knocking Sound Coming From Driveline.

r31et
 Share

Recommended Posts

r31et Explorer

r31et

Posted
Posted

hey all I have a bit of a serious knocking sound coming from the drivline of my cefiro. it started after dropping 2nd gear and then missing third and droping it in hard when i found it, at first i thought i was the gearbox as it had been making a bit more noise than usual, so i swapped the gearbox for a known good one and when i took it for a drive the noise was still there. Im fairly sure it isnt the motor because it can be revved as hard as you like and makes no unusual sounds if i have the clutch in or have it in neutral. so im thinking is could be the tailshaft or the diff although it sounds like its coming from the middle of the car. I also didnt take the clutch apart when I had the box out. I wont make the sound the clutch is in so it is probably on happens when there is load on it.

any help appreciated cheers Ryan

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • Dose Pipe Sutututu
      AC Compressor

      By Dose Pipe Sutututu · Posted

      There's probably an underlying issue with the A/C system too. I recently fixed mine, now it's fully control by the Haltech and car's factory HVAC controller  Have a squiz here:    
    • deev236
      Stagea S2 RS Four S Misfire/Rough Idle

      By deev236 · Posted

      And by the way, I've also checked the ECU diagnostic numerous times and got a bad O2 sensor code and initially an Ignition Primary code, which is why I replaced the O2 sensor and all the ignition components (coil packa, plug and loom). No codes have been coming up lately despite the ongoing issue.
    • deev236
      Stagea S2 RS Four S Misfire/Rough Idle

      By deev236 · Posted

      Hey pber13, unfortunately still no luck. At this point the following has been done with little or no success: - Spark plugs replaced, gapped to 0.8mm - Splitfire coilpacks installed to replace originals - Replaced Ignition Coil/Coilpack harness with a new genuine nissan one - New fuel filter - Replaced AFM/MAF sensor - Injectors have been thoroughly cleaned with an online flush (without removing) - Upper engine and inlet decarbed - blew tons of black smoke out, cleared the carbon deposits from the top of the engine and exhaust.  - IACV removed and thoroughly cleaned with carburettor cleaner - O2 sensor replaced with new and genuine one -  Smoke test revealed no vacuum leaks - Healthy compression test of 160psi across all 6 cylinders Overall the car does run a lot smoother now, no backfires between gear shifts like it did originally... but the rough idle when warmed up is still there. It may not even be a misfire but simply a rough idle. Seems crazy to me that so many people have had this issue and seemingly no one has gotten to the bottom of it, or at least never bothered to post if they did! Hope you have more luck than I did pber13, I'm at a point now where I'm just going to try to ignore it unless it gets worse. Would love to fix it but I've genuinely run out of ideas of what it could be.
    • R3N3
      AC Compressor

      By R3N3 · Posted

      I got the full frenchys kit too. Really awesome kit. Easy to install my only complaint was the hardlines I think could be routed differently (I modified mine) but I realise the kit needs to suit multiple applications. This was the hard lines before I modified them. They were touching the wastegate pipe. I ended up reducing the distance between firewall and first bend. The made it so they tucked along the frame rail.
    • pber13
      Stagea S2 RS Four S Misfire/Rough Idle

      By pber13 · Posted

      Deeve, I don't suppose that you've made any progress on this? My Stagea has the exact same problem, and just like you, I've read through as much as I can online, with no real progress. My car isn't throwing any codes at all, which is a little frustrating. I've changed plugs, checked the wiring and harness. A new MAF gets here next week, but I'm not hopeful it will solve the issue.
×
×
  • Create New...