Jump to content
SAU Community

Recommended Posts

Black V35 lowered with chrome rims at Bankstown

Red and White V35 at Kingsford Sydney.

Both there everyday. However i havn't seen the white one for quite a while...think the girl sold it

Edited by Marshan
  • 2 weeks later...

Someone posted this on ZClub today:spotted V35 with nice TE37 replica wheels this morning on princess hwy heading towards city, plates JTAN-83....(i think) ted V35 with nice TE37 replica wheels this morning on princess hwy heading towards city, plates JTAN-83....(i think)

Edited by ZEDGRL
  • 3 weeks later...

Spotted a silver v35 coupe going through lights at Nebo rd Mackay QLD with black rims, had back wing with nissan + 350gt badging looked very dirty appeared to be a miner driving it as i noticed hi vis shirt. anyone here?

  • 2 weeks later...

- Silver V35 Coupe parked on Ballarat Road next to Footscray Park at around 10:30am

- White V35 Coupe chick driver (not sure if it was Marie or not) turning right from Hawke Street into Spencer Street at around 5:30pm

- Red V35 Coupe at the roundabout near VicRoads and the local court in Sunshine at around 6:15pm

Edited by 81gSKy

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Just a follow-up on this topic. From what I can tell so far the rusty residue on the engine block might be unrelated to a coolant leak or maybe just older than anticipated. After driving it from the winter garage to my friend's garage I could not see any new traces of coolant leaking there, but I will test this properly once I was able to fully warm up the car and drive it for a bit. I think I can agree that the whole porous engine block stuff is kind of nonsense, but there is just a silly amount of true, false and half-true information on anything Skyline-related on the internet.
    • hrmmm , not mine , easter plans to pull engine not happening     
    • I removed the IACV, cleaned it and reinstalled.  I found a video on youtube that helped with the whole process, the guy then said the idle needed to be set, so the process was to get the vehicle up to operating temperature, unplug the TPS, set the idle screw in the IACV so the RPMs were around 600, then plug the TPS back in.  After I reinstalled the IACV, the car started (because, it was a cold start), once it warmed up, the car died, I adjusted the idle screw to see if that helped anything, it did not, I had to wait about 3-5 minutes, then the car would start back up. Only to shortly cut out, and only crank.  I loosened the TPS to see if adjusting that would do anything, and when I would rotate the sensor clockwise, there was a humming noise, but it would go away when I got the sensor in the horizontal position.  It only made the hum noise with the key on.  What do you guys think? 20250414_172604.mp4
    • Quick update.  The engine grounding strap was replaced, the engine is now happily running.  Tested the voltage drop before replacing the strap, was about 1.2ish volts down between engine to battery, chassis to battery. With the new grounding strap, pretty much no voltage drop at all. 
×
×
  • Create New...