Jump to content
SAU Community

Recommended Posts

attended the dynomotive dyno day on saturday and met a older fella who owns a blue series 2 R34 GTT which pulled 238rwkw. was in beautiful condition but shame it was an auto. would have got more info but his old lady kept bugging him to look at some other cars

Keep running your mouth Kris. You already look like a dumb ass for over reacting to Jamie's comments. I have zero problems talking to you face to face. I dont have a personal problem with you, I just have a problem with people who threaten people over the internet, people who have double standards, and people who cut others in half for speaking their mind. If you want to continue this conversation civilly, PM me. Otherwise leave it as it is. Cheers

I rocked up to Hallam Kebabs just as a white S2 R33 was leaving. Couldn't see the driver or any SAU stickers, but it had bright blue LED parkers and drove off down the road with only them and the foggies on :ninja: Other than that, appeared to be driven responsibly and all that (no usual sideways exit onto hallam road...)

Haha I was in the far left lane sitting at the damn 80km/h limit, did you see me?

Was coming home from Stereosonic :)

You must have been going a bit slower cause I was going 80 too :) Yep spotted you... always get excited by a bayside blue r34 :( .

I drove past the showgrounds when Stereosonics were finished... cops everywhere. Was glad I didn't have my R33 anymore ;)

Nice car btw!

Ditto!

You must have been going a bit slower cause I was going 80 too :blush: Yep spotted you... always get excited by a bayside blue r34 :) .

I drove past the showgrounds when Stereosonics were finished... cops everywhere. Was glad I didn't have my R33 anymore :)

Oh haha yeah 80 on my speedo shows 76 on my GPS so that's probably why I was a bit slower woops!

Plenty of cops out after Stereosonic, drove past and alongside a few of them but they were mainly looking out for the people walking the streets causing chaos! :)

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • There are several aftermarket options available, from not-too-painful moneyhttps://justjap.com/collections/driveshafts-bearings/products/d-max-reinforced-replacement-rear-driveshaft-set-fits-nissan-s13-s14-s15-r32-r33-r34-c35 and  https://justjap.com/products/crank-motorsport-billet-rear-axles-fits-nissan-skyline-r33-gts-t-r34-gt-t?srsltid=AfmBOorQk4xkGUa98kO7v2ePLUiNt-HRrM2AwWNw9mbSIVE1ujBVwY__, all the way up to The Driveshaft Shop https://driveshaftshop.com/skyline-cv-axles/
    • Yeah based on old XRC5964S specs, it looks to be roughly GTX3576R sized? But this 5964S compressor will flow 90lb airflow somewhat similar to the compressors in both the GTX3584RS or G35-1050.. I fully expected the 0.64 rear A/R to choke up top - seems way too small from typical convention - but these are seemingly beneficial over the prior 0.82 results.. Be interesting to see if he comments on the EFR question in that thread - he mentioned in a prior video that BW EFR's were the "cats pajamas 10 years ago", but by the sounds of things all his kits have been using Xona for quite a while now.
    • Yeah it’s still got the oem manual gearbox and clutch, only kinda mods are a blow off valve, coil overs, and a aftermarket intercooler. Also had it for about 2 months now with a lovely midnight purple paint on it.
    • Yeeeppp, been following a lot of the testing on the latest Xona stuff and there are some mental results.  He also went over 1000hp @ 4 hubs on his Mainline with a XRE6364S (63mm) which was also well into the 20psi range before 4000rpm on a 2.5. Crazy stuff. Fwiw the XRE5964S is basically the modern equivalent of their old HTA3582 - would drive nicely enough on an RB25 or 26, but proven capable of a huge amount of power if you want to spicy with rpm tho even at sane boost levels will make stout numbers 
    • The axels in my R33 seem tired, and have a bit of play in them. I cannot find any new of course, not interested in buying used, but I am looking to see if anyone can identify some cross compatible axles. In the states I have seen suggested for S chassis the J30 axles, however for the skyline (as best I can tell) the lengths are about an inch off (2.5cm) on both sides. R33 my measure L 22" R 24.5" GPT L 22.5" 24.25" J30 L 23.5" 25.5"  so shaft length is probably an inch wider. Not sure if someone has another still remanufactured option besides the J30. I figured worst case I can buy a pair tear them down and swap the center shaft. My other option was reaching out to GSP to see if they cannot piece together a set, since the axle stubs are still manufactured, I wouldn't think it be that hard to find a shaft or make a shaft work. 
×
×
  • Create New...