Jump to content
SAU Community

Recommended Posts

Ladies & gents. I have for sale;

A set of HKS Hyper Damper Coilovers for an R32 - Very good condition. $1150 ono **SOLD**

And a set of R32 GTR Wheels Very good condition - slight gash on 2 wheels otherwise very good. $700 ono **SOLD**

I also have a stock R32 exhaust $100ono & R32 four door floor mats very good condition $80ono

Please pm or reply to [email protected]

Cheers

post-12006-1206769402_thumb.jpg

post-12006-1206769449_thumb.jpg

post-12006-1206769511_thumb.jpg

hey man. are the coilovers adjusted to the lowest they go in the pic? how low did they sit when you had em in ur car?

Hi mate,

The rears are adjusted to the lowest level - the fronts are sitting about halfway. They sat pretty low at the rear (i'll see if I can find a pic) had to get the guards rolled. The fronts I left for practicality purposes. (price negotiable)

Cheers

hey man. are the coilovers adjusted to the lowest they go in the pic? how low did they sit when you had em in ur car?

here you go mate

post-12006-1207191592_thumb.jpg

spring rates for coilovers?

were they are hard ride?

and know how many kms on them?

Don't know - but pretty stiff.

They were hard but not uncomfortable - i drove about a year on them so around 15000km. They were fine before my car was written off!

Cheers!

Daniel ,

let me know if they fit R32 GTR as i am keen.

http://www.piaa.com.au/prod538.htm

I have sourced the above site - these are for hypermax II but has info on coil rates etc

Daniel ,

let me know if they fit R32 GTR as i am keen.

They'll fit R32 GTS, GTS-t and GTS-t Foor door.

They will not fit an R32 GTR or GTS4 because of the driveshaft at the front (rears will fit).

Sava dude,

its Sean from the old FLM days,

i want your floor mats, you know if they are the same as 2 door?

catch ya round.

Yo mate!

Yeah - pretty sure they are. You can come around and test them if you want?

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • This seems problematic and unlikely at the same time. Vanilla RB2Xs have hydraulic lifters. They do have "zero" clearance, but only when running with oil pressure inside them. When not running, you should be able to compress them and obtain heaps of clearance. RB26s and Neos have solid lifters. They should have ~0.3mm and ~0.5mm on the inlet and exhaust respectively. If they have zero clearance then bad things are happening. With nothing else being wrong, it would mean that the valves would be held slightly (ever so slightly) open when they are supposed to be closed and it should have all sorts of problems when running, caused by leakage in/out through the valves. Or, zero clearance can indicate severe valve seat recession. None of it is good. Have you used a piece of hose as a stethoscope to try to localise the noise?  
    • Sorry for reviving an old post, but I'm having the same hot idle tick issue. Did anyone ever find out what it was?  I have checked/ replaced Injectors Coils checked Lifter clerance (is at zero) Checked Cam lobes Replaced exhaust gasket and studs Would appreciate any advice this is driving me nuts  
    • There's a huge reason manufacturers are tuning in dead flat torque curves... Make them reliable (and more drive able)
    • What HVAC actuator is under the steering wheel? Do you mean on the RHS of the centre console, immediately to the left of your shin? If so, then yes, it is probably that one, because that is the mode door actuator, and from what I know, it's still a pain in the arse to replace. I don't know about whole dash out, but you certainly have to rip into the centre console section. I don't know if it's covered in the workshop manual, as I haven't spent much time looking at those parts of it. (and by "the workshop manual, I mean the R32 GTR one, which is the most comprehensive one we have, and it should be similar enough between that and later cars to serve as a guide).
    • ...oops. forgot the TCU end...
×
×
  • Create New...