Jump to content
SAU Community

Recommended Posts

  • Replies 410
  • Created
  • Last Reply

Top Posters In This Topic

Top Posters In This Topic

Posted Images

Hi all

If i were to fill in and send the L2S Cams form by the end of the week do you think i would have it by then and be able to enter this event? :rant:

Cheers Joey

even if you dont you can get a tempery one from them...Think its on the form down the bottom a slip you can tear off

Or could just get your AASA Joey :) both last a year and recongnised at most places

Guest Joeyz
even if you dont you can get a tempery one from them...Think its on the form down the bottom a slip you can tear off

Or could just get your AASA Joey :rant: both last a year and recongnised at most places

Thanks Jess, I'll fill it in and send it off today. Hopefully it wont take 3 weeks

Should I say that I'm in for the day then?

Thanks Jess, I'll fill it in and send it off today. Hopefully it wont take 3 weeks

Should I say that I'm in for the day then?

Yep sure can!!

Tear off the 30day licence part at the bottom of Section 4 , Page 4 on the form :rant:

Cams Form : http://www.cams.com.au/downloads/paperform...Application.pdf

Guest Joeyz
Yep sure can!!

Tear off the 30day licence part at the bottom of Section 4 , Page 4 on the form :rant:

Jess

Do i just keep that just incase i don't receive the licence back from Cams and just bring it on the day?

Steve

Please add me to the list and i'll put the payment through by tuesday next week.

Thanks Joey.

Jess

Do i just keep that just incase i don't receive the licence back from Cams and just bring it on the day?

Steve

Please add me to the list and i'll put the payment through by tuesday next week.

Thanks Joey.

I need you to send a copy of Cams form to us also so we know you have applied

Now guys, Just to make a note of this.

If you want to apply for a CAMS L2S for this event I would advise to put them in straight away because they can back up and take 2-3 weeks.

Ando, seeing as you no longer have the JapTaxi, are you going to enter your AusTaxi?

Hah ha the VY would bust a nut before the first set of cones.... so no i will quit while ahead... well quit till i get behind another vehicle.. ;) *Chubbs* ;)

Guest
This topic is now closed to further replies.



  • Latest Posts

    • Haha yea it's a bit of a weird setup at the moment, just wanted to make sure I sorted out any headaches before dyno day. At the moment I've changed the exhaust manifold, turbo and downpipe, 460lph fuel pump and rising rate reg as well as the previously mentioned headstuds and gasket. The nistune was already mapped for the car as it was and drove around for a few months no worries. The plan is to run flex fuel hence the big pump, which I've wired direct to the battery through a relay to avoid voltage issues.
    • Um. Was the ECU the same as the one previously there? I know R33's needed R32 GTST ECU's or other tomfoolery to run Nistune. This is such a wild setup. Most people would plumb in the turbo then not drive the car (i.e tow it to a tuner). What's actually changed since it last ran?
    • I'm a bit stuck with this one fellas, I recently decided to undertake a turbo conversion on my GTS-4, ended up pulling the motor to replace all the seals and do an mls head gasket and arp head studs while I was at it. Everything has gone according to plan, no oil or coolant leaks, compression checked out, and decided to give it a test before I book it in for a tune As it stands right now, the turbo only has oil lines plumbed so that I don't put boost into my untuned engine, and I'm using the factory GTS-T crossover pipe with a maf and poddy as a temporary intake. The car starts with relative ease and idles amazingly, however as the title suggests it really doesn't want to rev up, runs very smooth but almost feels choked out and unresponsive to the throttle, almost like it's running lean or something? I've triple checked my vacuum lines and timing with a timing light, injectors haven't been touched as of yet to avoid flooding the engine and worked perfectly beforehand, new plugs and coilpacks, I've even unbolted the cat just to see if it spontaneously collapsed, no dice The car currently has a nistune r32 gtst ecu installed so I have no way to check for fault codes. At this point I'm a bit stumped. Is this normal behaviour for a car with a turbo bolted onto the exhaust going nowhere? I'd imagine the turbo wouldn't cause this much restriction in the exhaust without the boost going through the intake. Any ideas? If necessary I can link a video of how it responds to full throttle while in neutral.  
    • Insert tab A into slot B?
    • Instructions seem simple enough to understand.....
×
×
  • Create New...