Will A Series 1 Rb25det Engine Loom And Power Fc Be Compatible For A Series 2 Engine

[kretch]

Gday as the title says, is it possible for a series 1 engine loom to be fitted to a series 2 engine? And a would a power FC tuned for the series one engine be OK to fit with the loom to the series 2 engine?

[stricnynel0s]

i think, if u change coil packs, and get an ignitor you will be ok

[kretch]

Thanks mate, anyone else got experience in this??any help would b great

[kretch]

cmon someone on here surely must know definatly if it does or whats needed.....??

[Adriano]

CAS is different, and the series one wont fit the series 2 motor without modifying it.

[Duncan]

but the plug to both CAS are the same, so just use the cas for the motor you are using. it is all interchangeable as long as you use ignitor and s1 coils, or just s2 coils.

[kretch]

so duncan ur basically saying i dont have to change anything right?its all interchangable?doesnt matter s1 or s2 ingniter and coils.....

[Duncan]

sorry I wasn't clear. You use the stuff that matches your engine loom so yuo have the right plugs for ignitor etc. But it doesn't matter if the motor is from s1 or s2 as long as yuo change all of your old bits over.

i did the opposite of what you asked above, s1 engine in a s2. kept the s2 coils and it was all fine

and the computer is the same for both to answer your other question.

[paulr33]

be sure to note AFM setup is different

S1 is 4 wire AFM

S2 is 3 wire AFM

its the same phyiscal AFM , just S1 has ground and signal ground, where as S2 shares 1 ground

[kretch]

ok thanks fellas doesnt thats pretty easy then just AFM and igniter