Jump to content
SAU Community

Recommended Posts

  • Replies 76
  • Created
  • Last Reply

Top Posters In This Topic

one thing that all rb motors are going to need at one stage or another is a overhauled ignition system, wheather you go for replacement direct fire, or go for a wasted spark system, this is just as good as putting a free flow exhaust manifold.

you notice the difference.

you'll have money left over to buy a programable rom for your ecu.

your a goose.

i have over 350 rwkws with the standard coils and ignition system, running 24psi daily.

would you like to respond to this?

My advice:

get a bigger dump pipe and front pipe (does not have to be split, the big bell mouth ones work well too). also doesn't have to be new either. That will be anywhere from $250 to $500 depending on what you get and if it's new or used.

then I would get your ECU chipped and tuned. the toshi remap seems to be popular. when you get this done also fit a cheap bleed valve and up the boost to 11 or 12psi even that extra 1 or 2 psi will make a difference and make the car feel a bit nicer. The remap and bleed valve will eat up the rest of your $1000 budget. but you should get some good gains out of those mods. :down:

Mate I am actually in the same boat as you except I have an R34 GTT - currently has cat-back (came free with car) and boost controller ($30) running 10-12psi. I also want to spend minimal money - My plan is:

Dump pipe - $199

Hi Flow cat - $160 (you already have this)

FMIC - $300 (not really needed but hey I like the look).

SAFC NEO - $250 (brand new delivered, buy from the USA dont get ripped off here)

Tuning for above - $100-200.

Thats $1100 for me or $649 for you (as you have cat, R32 wastegate (10psi) and dont need FMIC). Personally I think SAFC is a wise investment, these cars run sooo rich with exhaust...I get 350km to a tank driving normally, everything is serviced/new, which leaves the air/fuel tune.

I only have one rule when modifying and thats make sure everything you buy can be taken off and sold seperatly when you sell the car, i.e. KEEP ALL YOUR STOCK PARTS. End advice.

Hey thanks for that!

Would you maybe pm me the details of where i can get the SAFC?

Whats the difference between the toshi remap, the jaycar fuel controller and the SAFC tune?

Hey thanks for that!

Would you maybe pm me the details of where i can get the SAFC?

I havn't looked in a while but I just did a google search of US performance shops - also US Ebay had multiple new SAFC NEO's for under $300 delivered to your door in Aus.

^^ Also in responce to Decim8 I have had multiple X-Force exhausts (previosly on a WRX and a VR4) and never had any problems with them, why pay double for a brand name? But thats just my opinion not saying your wrong.

if you shop around you should be able to get a FMIC kit and front section of your exhaust for $1000...

You should be able to fit it all yourself, they are both easy to do if your not confident just take your time...

I think the best mods are the one's you d yourself a lot more rewarding.

I speak from experience when i say

get someone to fit the dump for you!

Good luck trying to undo the stock screws without snapping anything.

Is a Nistune ROM and remap essentially the same thing?

Hyperdrive in W.A say they can remap it and tune it for $800.

Is that reasonable?

Also, i have heard that remaps are better then a SAFC and tune, but i have nothing to base that on.....

Nistune is an advanced re-map. It accepts live changes making it easy to tune.

It also comes with software pretty much featured to the level of a power FC.

I had two rb20 cars.

One got an SAFC and 14 psi and the other stock boost and nistune.

http://butters.throwinghandles.com/file_st...veditvsSafc.jpg

Thats the comparision graph. The nistune does make less power but that is only becuase it has no extra boost.

You can clearly see the difference in the quaility of the curves. I won't buy an SAFC again !!

Driving them is worlds apart to the Nistune is so much smoother and feels almost as fast as the higher hp tune.

OH and as for SAFC not making any more power.

sus out this before and after SAFC.

http://butters.throwinghandles.com/file_st...fcTuneSmall.jpg

the AFR's of the scale without the SAFC and thats just with cooler, zorst and boost.

i think in the end you gotta try things for yourself...

i have been running 14psi with the stock turbo and smic on my 32 for 2 years/50000'ks and its still going strong....

i also have one of those china manifolds that is supposed to crack a week after you buy them and mines been fine for 50000k's

of all the mods i have done i have found that good tyres are the best bang for the buck.....

i have one of those ecu remaps and i can hardly notice the difference...

taking out the sub, rear seats and all the trim behind the front seats made heaps more difference..

but changing the castor, and camber bushes to adjustable did f**k all..

thats me and my situation its gonna be different for everyone...

Ok here's the update...

Dump is definately on the cards, i thought i might first just try to source something decent second hand. Anyone?

As for remap i did some research and spoke to Toshi (Great guy who knows his stuff! Thoroughly recommended!), he was even kind enough to show me what he could do on my car with the road tune, try before i buy type of thing which was a real learning curve for me. BUT even though my car is still as i first posted as i didn't really feel any more pull from the tune, a smoother overall delivery of power definately, but not any more pull. Toshi recommeneded i try a front mount, dump pipe, hiflow, fuel pump and airflow meter to really make the most of the tune, which i can appreciate but i'm not going to do...

Toshi spent a long time and did a great job but i just think my mods i have done even when i get the dump pipe can't justify the tune... not just the money side of things but just the fact it didn't change a hell of a lot with my setup..

I'm not sure if anyone else has experienced this with same mods?

So i'm still not sure what to do next...

A few have said boost controller and up the psi but my friend had a bad experience with boost creep in his 33 with similar mods except for FMIC snd dump pipe and blew the turbo, which kinda scares me off.

i think in the end you gotta try things for yourself...

i have been running 14psi with the stock turbo and smic on my 32 for 2 years/50000'ks and its still going strong....

The R32 Rb20 has less ariflow than the Rb25 in the R33 gtst and as such the turbo can tollerate a little higher boost, as at the same pressure the Rb20 airflow is lower meaning less shaft speed on the turbine. Less power too.

No one has really mentioned replacing the 02 sensor?? Have you replaced it since youve had the car?? if your going to put on a dump pipe you may as well spend the 100 or so bucks for a new one as you can remove the old one and install the new one while the dump is off? good for a few kws i guess if you still have the tired old factory O2 on there. i believe they are supposed to be replaced every 40,000ks or something??

but yeah definitely go dump pipe/hi flow cat converter first

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Latest Posts

    • OK, that is a helpful description, because that sounds exactly like a bleeding issue in the clutch....these are hard to bleed manually even when the damping loop has been removed. I'd suggest bleeding again....start by filling the master cylinder up and opening the bleed nipple. Come back and check every now and then that the master cylinder is not empty. Let it gravity bleed for a few hours and see if that improves
    • I replaced the whole clutch line with the chase bays braided hose, I think it removes that loop, is it the short hose that comes immediately off the slave or is there a drawing in the manual to find what you’re referring to? It was just re-bled when I upgraded to the nismo slave, old slave worked fine but I thought that might help, didn’t change a thing. It’s like the first half of the pedal is pushing air and then when it finally actuates the master the friction zone is tiny. Makes it practically impossible to launch the car
    • Yep, that was one of the things we learned fast in the past with our MX5. When you drive with the top down, you are effectively standing out in the sun, 100% of the time, and not getting in any shade (because roads aren't shaded generally!). Just like standing out in the middle of a field on a sunny 27C day is a bit of a bad plan, so is sitting in a MX5 without sun protection.
    • I also just ordered some Frankenstein bolts and side mounts to fit a hard top Just in case I do find one, basically so it doesn't need to be fixed to the car with only the front latch.......and then gaffa tape to keep it in place for the RTN journey from wherever I get it
    • If your temps are fine now, you probably won't have any issues with where your vents are as they don't look right up at the windscreens high pressure area, so any differences when giving it the beans for extended happy laps would be minimal, but, they should vent heaps when stuck in traffic  Much like how that reverse cowl on my SS let "visible" heat out when stationary, but, because it was basically at the windscreen my coolant temps on the Hwy actually raised because air was being fed into it at speed (110kph), to only come back down to around 90° when I got off the Hwy And your 100% correct about the NC currently not needing vents, but, if I was to add a turbo, and a oil cooler and intercooler in front of the condenserand radiator, and then take it to the track???? It is apparently a recommend requirement if I don't want to worry about coolant or oil temp issues, but, any of the above are possible scenarios, over time As it sits now, with the triple pass radiator and stock air conditioning system, I have absolutely no issues with either temps or air conditioning efficiency, I've been basically daily driving thie car for the last month, both on the Hwy, and peak hour, bumper to bumper traffic, but, that's pretty much expected from basically a standard engine  Talking about no issues daily driving, it was 39° the other day and I was sitting in bumper to bumper traffic on the M5 and then M7, with the top down, and with the air conditioning blowing nice cold air on my feet, balls, and face, well, there was one issue, my head and arms got pretty sun burnt Note to self: leave a hat and sunscreen in the car for such days 🤣
×
×
  • Create New...