Jump to content
SAU Community

Recommended Posts

  • 3 weeks later...
  • 2 months later...
  • 3 months later...
  • 3 weeks later...
  • 3 weeks later...
  • 1 month later...
  • 4 months later...

This is mine

Exterior:

Genuine Jun rear pods

400r skirts

Genuine gtr wing

Sedan. Indicators and grill

Can't remember front lip

Engine:

Genuine ARC airbox (made for gtst)

D1 Spec catch can

Cusco strut bar ( was old so rattle canned red )

4 coil aluminium radiator

And other bits

Wheels and Suspension

Random China tyres

Xxr 531 (17x10 +20 )

Bc BL coil overs ( gold plate )

Cusco upper camber arms ( yet to be installed )

post-140477-14359342586_thumb.jpg

post-140477-14359342822339_thumb.jpg

post-140477-14359343072798_thumb.jpg

post-140477-14359343549897_thumb.jpg

  • Like 1
  • 2 months later...
  • 2 weeks later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • This seems problematic and unlikely at the same time. Vanilla RB2Xs have hydraulic lifters. They do have "zero" clearance, but only when running with oil pressure inside them. When not running, you should be able to compress them and obtain heaps of clearance. RB26s and Neos have solid lifters. They should have ~0.3mm and ~0.5mm on the inlet and exhaust respectively. If they have zero clearance then bad things are happening. With nothing else being wrong, it would mean that the valves would be held slightly (ever so slightly) open when they are supposed to be closed and it should have all sorts of problems when running, caused by leakage in/out through the valves. Or, zero clearance can indicate severe valve seat recession. None of it is good. Have you used a piece of hose as a stethoscope to try to localise the noise?  
    • Sorry for reviving an old post, but I'm having the same hot idle tick issue. Did anyone ever find out what it was?  I have checked/ replaced Injectors Coils checked Lifter clerance (is at zero) Checked Cam lobes Replaced exhaust gasket and studs Would appreciate any advice this is driving me nuts  
    • There's a huge reason manufacturers are tuning in dead flat torque curves... Make them reliable (and more drive able)
    • What HVAC actuator is under the steering wheel? Do you mean on the RHS of the centre console, immediately to the left of your shin? If so, then yes, it is probably that one, because that is the mode door actuator, and from what I know, it's still a pain in the arse to replace. I don't know about whole dash out, but you certainly have to rip into the centre console section. I don't know if it's covered in the workshop manual, as I haven't spent much time looking at those parts of it. (and by "the workshop manual, I mean the R32 GTR one, which is the most comprehensive one we have, and it should be similar enough between that and later cars to serve as a guide).
    • ...oops. forgot the TCU end...
×
×
  • Create New...