Jump to content
SAU Community

Recommended Posts

Item:RB25 Gearbox's, one has a full conversion kit one is a box on its own

Age:no idea

Condition:not sure on the condition, they were fine before the cars crashed

Price:$1200 for the box on its own, and $1800 for the whole manual conversion kit (has a good clutch on it)

To Fit:r33 gtst or whatever you like (What car)

Location:Newcastle

Contact:me by PM

Comments:

I am wrecking a whole black r33 gtst, has a decent sized turbo on it and injectors and some 17" SSR wheels (look like jap wheels) $600 for the wheels with legal tyres

Haltech e11v2 computer, comes complete with plug and play harness for R33 GTST and map sensor and air temp sensor, am looking for $1700 for the computer ONO.

I am not pulling the car appart to list parts individually, but you are more then welcome to request parts in this thread. no front end parts are available as it was hit very very hard. pics comming soon.

Can sell the turbo and dump and oil / water lines & injectors & computer & fuel pump all together if someone wants a power upgrade which made 300rwkw on 14psi

Edited by Guilt-Toy
Link to comment
https://www.sau.com.au/forums/topic/217108-rb25det-5-speed-gearbox-x-2/
Share on other sites

the turbo looks like its a VG30 rear with a .70 comp cover and massive wheel in the front.

injectors are red, might be nismo 740's

Do you know what the turbo and injectors are?

added pics of the wheels and other bits

Blitz BOV $200

leaving the wheels at good same price, even though they are good quality jap wheels they could do with a paint job, some gutter scraping on it but it only chipped the paint.

post-1240-1209598796_thumb.jpg

post-1240-1209598831_thumb.jpg

post-1240-1209598868_thumb.jpg

post-1240-1209598889_thumb.jpg

post-1240-1209599012_thumb.jpg

Edited by Guilt-Toy

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Nah it factory manual not sure about ratio but it looks like there’s been some work at the rear 
    • so I need a new speedo cable 
    • Throwing my spoon to the soup here a bit.  When I installed a 044 back in 2012, along with the direct power mod, the car became very difficult to start. To a point I burned one starter motor as I was late for work and tried to get the thing going. With some tuning and careful use of gas pedal when cranking it became bearable. Trying to make this short as possible, but the 044 died after 2-3 years, after which I went with an AEM 320lph pump, which also died after about 4 years to my dismay. After that I went with a Nismo pump, and while trying diagnose an emissions problem, I noticed for the first time that my fuel pressure was 5bar/72psi on idle, and that removing the vacuum line did nothing. After monitoring the situation, and removing the direct power feed and going back to FPCM in attempts to remedy it, I noticed there was fuel in the pressure regulator vac line. Kept the FPCM, installed AEM external regu and the car became sooo much better in every way, including starting. And I had driven it like it was for 11 years.. Anyway, I agree these are likely two different problems, and the FP problem you just haven't noticed before. I do not know much about haltecs, but what first came to mind was the CAS, which probably is not there any more. So how is the wiring from haltec to gauge cluster? How is the battery voltage and alternator?
    • Your car was auto before? You have different diff ratio (auto vs manual i think? or n/a and turbo?)
    • +1 for getting a screen off alibaba, CarPlay/Android Auto is vastly better than whatever navigation cars had 10 years ago. I got an Android screen for my 2015 BMW, huge difference. Fully compatible with factory stuff including iDrive controls.
×
×
  • Create New...