Jump to content
SAU Community

Recommended Posts

any suggestions? even if I set the threshold very low, eg 1, it will not show the dash light. I am running datalogit which shows that the pfc is reading more than 1 knock so the sensors and wiring to the motor are ok.

globe in the dash is OK but thats as far as my troubleshooting has got.

this is on an r32 gtr which i understand should flash the cat temp warning light.

Link to comment
https://www.sau.com.au/forums/topic/217143-pfc-not-showing-knock-light/
Share on other sites

hmm hope not, I have a nismo dash and it doesnt have an engine check light.

Can someone confirm? I will change back to std dash if so

if that is the case you might not have to go ack to standard...you could probably wire up a seperate light kinda like a shift light or somthing..my r32 used to flash the check engine....but it was a GTST so that probably does not help you sorry ;)

yeah youd be able to wire up an independant light

get an auto sparkie to help

hey Bunta, almost 2yrs on the the turbo I got from you (that slide hiflowed) is still going strong dude ! ;)

my gtst doesn't have a check engine light. It flashes the exhaust temp light instead :/ As far as i knew no 32's had a separate engine/exhaust warning light, they share the same one.

When you get the stock ecu to give you the error codes it also flashes the exhaust temp light.

There's a single wire coming off the ecu for the check light anyway. Not a hard job to strip a section near the ecu and check for a switched earth (I assume earth as it seems to be the more common switch on the ecu) with a multi meter set for continuity and earthed on the other probe. You could start the car and listen for the annoying beeps if you have knock set to 1 as i'd expect it to have a nice little 5-10 point spike on start up.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Thanks for that Paul.  Do you think if I posted a picture you'd be able to remember where it went? 
    • Sorry Duncan, I didn't get a notification for the replies.  Thanks for responding!  It's a full Android device, but does allow you to use CarPlay/AA as well.  This is the one I bought from NaviRS on AliExpress: https://www.aliexpress.com/item/1005006368602668.html?spm=a2g0o.order_list.order_list_main.111.59aa1802JDzQ0E - the 2K 8G-256G CAM variant but it seems to have gone up by £170 since I bought it!  My purchase was £307.14.   It's not the fastest thing in the world but performs perfectly adequately.  It stays on standby unless I disconnect the battery and let it power down, then it's just a fairly standard Android bootup time from cold.  The DSP Equaliser is very nice and made the standard stereo system sound pretty decent compared to the stock screen.  Perhaps I can take a video of it when I get a sec. It *allegedly* supports the reverse camera, but I'm yet to get that working.  It has options for reverse cam (a camera unit can be bought separately) or 360 cameras (also bought separately).  To be fair it doesn't seem to detect that the shifter was put into reverse but I'm working on a theory about this as well.  At the moment I'm going without which is a bit annoying considering the car is an absolute canal barge but so far I haven't caused any damage I'll grab a picture of the wire I'm missing later today when I can get outside.  My theory, by the by, is that not only is the head unit different, but the CANBUS network has different signals for the different years.  I think this because I have a spare AC panel from a newer Infiniti G37 (as opposed to my Nissan panel) which wouldn't control anything except the volume when I had it wired up with the stock system.  I'm going to throw it back in and see if the screen will respond to it.  I've just ordered an arduino CANBUS module so I can have a look at the signals going around the car and see if I can spot anything.  I'm thinking if I can work out what it's expecting vs what it's getting I might be able to translate and relay the signal back but so far just a theory anyway. I also found this on my travels, so far the only one that specifically matches my car: https://www.aliexpress.com/item/1005002822934280.html?spm=a2g0s.imconversation.0.0.33433e5fgttovi If you look at the picture of the before, it has the card reader slot, and the picture of the head unit is exactly the same as the one pictured in my original post.  I asked if they sell the cables separately but sadly they won't.  I didn't want to just buy this one because it's a super old Android version and only dual core - likely slow as hell. 
    • As above, you did refill the coolant and burp the system before running it again didn't you?
    • To be fair - you see the same thing for every clutch. There's always someone making an installation error.
    • Just saw this, redacted names. It's on a R33 GTS-t Facebook group. Looks like still teething issues.
×
×
  • Create New...