Power FC Install Issues

[djb23_gtst]

Gday guys,

Just plugged in my power fc into r33 gtst. Car starts fine, but engine check light stays on when engine is on.

I checked which sensors were not registering values in the "monitor" menu, and it showed no reading for boost and air intake temp.

Any ideas?

I reconnected my original ecu and she runs fine, so error codes when I do the engine diagnostic check.

Thanks for the help

Dan

[Torrens]

I had this same issue too.

Simply turn off the EBC option (it's a japanese yes / no symbols). If you have access to the hand controller it will be simple enough to do. If you cannot find the option, hunt down the english hand controller manual in pdf and it will show you where to find it.

Without hand controller it will be very difficult to remove (if at all possible).

[djb23_gtst]

Thanks

I realised after I'd posted that EBC option was probably on, as it had the same funky symbol as the other options he he he.