Jump to content
SAU Community

Compak Attack Tomorrow

blo2.6

By blo2.6,
in Events Archive

 Share

Recommended Posts

Swiper the Fox Grand Master

Swiper the Fox

Posted
Posted
What was the MPH for RH9?

The first run I saw was [email protected] off the line then planted it but not a clean run. I agree - radials on first meet, would have been better.

they ran a 10.6 @ 146 to finish up. shows the car will do a 9 with a better driver and set up.

i just would have liked to have seen it run on radials. I even offered them the use of our tyres and rims.

NXTIME Grand Master

NXTIME

Posted
Posted

Mark's car is definitely a machine! Would have been great to see it run a 7...

Was a good day, just a pity that it dragged out for so long before the eliminations started, and then ultimately, it got cancelled.

Swiper the Fox Grand Master

Swiper the Fox

Posted
Posted
Oh dam was waiting for RH9 to come out :)

Wonder why Croydon hasnt prettied up Devilish...

Mark's car was awesome, did the best burnouts..I didn't see twoggle? :)

from the other thread...

News on our car...

Got diff in and running friday....put Autronic in and had a few problems getting it running. Finally got it sorted late Saturday afternoon and tuned. The ATTESSA ecu was not recieving the correct signals from the Autronic to run the 4WD. We tried bridging over a TPS signal and lost the bloody tune!! The Autronic went bonkers and took an hour to recover it. Mark retuned the car in about an hour and by midnight had it running and making good power. We again got out the wiring diagrams and found that the earlier bridge we ran was on the wrong pin...bugger. Got the TPS signal to the ATTESSA and the 4WD came alive. However the output was making the TPS ecu input unstable and we decided at 2.30am to pack it up and concentrate our efforts on Marks car. Deciding that running the car while not 100% was not worth risking the chance of damaging it...so yes with only a few hours sleep that night we rocked up and set a new Aussie GTR record.

GTR32X Experienced

GTR32X

Posted
Posted
they ran a 10.6 @ 146 to finish up. shows the car will do a 9 with a better driver and set up.

i just would have liked to have seen it run on radials. I even offered them the use of our tyres and rims.

Hey i thought it was only @137mph

But not 100%.

 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • TurboTapin
      R33 GTS25 NA - Stalling when vehicle is at operating temp

      By TurboTapin · Posted

      Do the following first and get back to us. - Clean and verify your IACV - Verify for vacuum leaks/post MAF leaks. (Pressure test is the best and cheapest way) - Do you have a BOV with stock ecu/MAF? If so, remove it.     
    • DRoc81
      R33 GTS25 NA - Stalling when vehicle is at operating temp

      By DRoc81 · Posted

      Hey all, The skyline I have is stalling when the engine is at normal operating temp.  When starting it while it is cold, it'll run just fine.  I have replaced the battery (bad cell), I have replaced the fuel pump, fuel filter and clean the MAF sensor.  Any other suggestions?
    • DRoc81
      Shifting questions

      By DRoc81 · Posted

      Thanks for all the information on this.  I tried ordering the parts from Amayama website and all 3 Solenoids are discontinued and not available.  Does anyone have any other websites to suggest that I could find the parts?   Separate issue-- I will start a new thread, but basically the vehicle is stalling when warmed up.
    • TurboTapin
      RB25DET Solid lifter conversion

      By TurboTapin · Posted

      It's unfortunate what Tomei USA has done to Tomei's name in general. I'm very weary of ordering parts from them now. I only order direct from a Japanse source (e.g Nengun). At least their logos are different, so you end up knowing what you have. 
    • Rezz
      DeAgostini 1/8 scale BNR32 Nissan Skyline GT-R Nismo

      By Rezz · Posted

      Update Issues 5 (plus #4) - 10 After making a claim about issue #4's missing part, DeAgostini Japan sent a whole new issue #4 and it arrived about 2 weeks after that. That was back in early March. It took another 4 weeks to receive issues 5 - 13 though. This update is for issues 5 - 10. Ove the 5 issues the front left suspension and most of the engine have been completed. The quality of the castings and fit of the parts is quite good, it seems better than DeAgostini's BNR34 Skyline GT-R from the Fast & Furious 2 movie, which (to me anyway) doesn't seem to have as tight tolerances or quite as accurate castings.  Each issue has a lot of info about the 1989 - 1993 Skyline range and other Nissan models from that era, but the focus is on the BNR32 Skyline GT-R Nismo and the various racing it did in Japan, Europe (Spa 24hrs) and of course Australia. I've included some text translated with Google Lens in some photos and will add to them if there's anything worth including. 
×
×
  • Create New...