Jump to content
SAU Community

Recommended Posts

god the internet is good for essay writing procrastination

agreed. just how I managed to find my way on here..

I usually fill up when I hit the line just before E, like the second last line. About 40-43L goes into my tank which does seem odd as its 65L if I'm not mistaken??

Link to comment
https://www.sau.com.au/forums/topic/220381-fuel-levels/#findComment-3886728
Share on other sites

You should never run your tank under a quarter full, all pump fuel has sediment which sinks to the bottom of your tank and sits there contaminating the last few litres.

If you run the tank below 1/4 to may times you can clog and even damage the fuel pump.

Just some advice :rofl:

Link to comment
https://www.sau.com.au/forums/topic/220381-fuel-levels/#findComment-3887086
Share on other sites

Got any proof of that Mick?

I imagine the fuel filter would get most of that before it does anything harmful besides it's not like the petrol would have that much time to settle as the vehicle is moving around.

Yes I do have proof actually, it happened to my R31 a couple of years ago... It conked out on the way to work and after I towed it to work and pulled the fuel tank and pump out (worked as a mechanic at the time - handy) the pump was covered in the same brown slime that was sitting in the bottom of the tank.

It wasnt rust either, the tank was spotless after I drained and cleaned it.

The fuel filter is after the pump not before it, the pump is exposed to whatever goes into your tank. The filter is there to stop whatever gets through the pump and lines from getting into the fuel rail and causing a blockage.

You would be very surprised at what is in most people's fuel tanks, especially if they use crap quality fuel... Even the best fuel stations can get contaminated fuel reserves, if the truck that transported it wasnt cleaned properly or the huge underground tanks are contaminated it all ends up going into some poor bastards car eventually.

Link to comment
https://www.sau.com.au/forums/topic/220381-fuel-levels/#findComment-3887125
Share on other sites

I get 600km per tank highway driving. Thats with pertrol left in it, I didnt want to run it empty.

I think i am getting around 10ltrs to the 100+, cause i can get 10.5 to the 100km in canberra driving.

Edited by BNR32t
Link to comment
https://www.sau.com.au/forums/topic/220381-fuel-levels/#findComment-3896087
Share on other sites

His car is running rather laggy turbos which do help when it comes to keeping the fuel usage down.

My old mans r33 gtst is getting around 10lts to the 100kms aswell, he gets 550kms before filling up and thats with heaps of fuel left. Stock turbo with mild mods.

Link to comment
https://www.sau.com.au/forums/topic/220381-fuel-levels/#findComment-3901626
Share on other sites

  • 2 weeks later...
My old mans r33 gtst is getting around 10lts to the 100kms aswell, he gets 550kms before filling up and thats with heaps of fuel left. Stock turbo with mild mods.

to my knowledge the R33 gts-t's have a 45litre tank (correct me if I'm wrong)

Back on topic....

On average I can get around 400 - 450 untill i feel i really need to fill up (very close to empty) - usually fill up with 42-44 litres.

THe most I have ever been able to squeeze into my fuel tank was 46 litres with the fuel light on.

NOTE: I never squeeze more fuel in after the pump was clicked off if that makes sense

Edited by 33Sedan
Link to comment
https://www.sau.com.au/forums/topic/220381-fuel-levels/#findComment-3927708
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Bit of a late reply here as me and my wife have been really busy with new born twins. I finally got these issues fixed and it was something really stupid that caused all of this 🤦‍♂️... After alot of mucking around with trying to figure out what is causing these issues, I back probed one of the R35 coils on the power 12v supply, with the engine running it got 25v! And I thought, hang on..., this isn't normal. Measured my battery with the engine running to check for over charge from the alternator and it wasn't that. So then I dissconnected the R35 PRP coil harness and backprobed the power supply on the engine loom where the ignition coil harness connects, with the key on ignition (engine off) it measured 30v! So then I had to trace where that high voltage was coming from and it lead me to the brown relay "ECM & IGN coil relay" inside the cabin next to the ECU on the passanger wall. This relay feeds power to the ECM and ignition coils. Tried swapping it with another same relay. nah still 30v.. coming from the 2 green/white wires in the brown relay. So then I set my multi meter to the beep continuity mode and probed every fuse on the fuse box inside the cabin to try and find this high voltage power source. Wasn't any of the fuses inside the cabin. Then probed all the fuses in the engine bay and BAM, got my power source that was a 10AMP fuse called "ENG CONT". Pulled the fuse out, and what do you know... it was blown. 🤦‍♂️  So then I quickly replaced it with a new 10AMP fuse, started the car and yeah haha [insert extreme face palm]... The RPM blimping thing went away, car idles smoothly now like what it was before. I swear! I checked all my fuses with my test light twice before I created this forum thread. I think, maybe because one side of that faulty 10A fuse lit up on my test light, I must have thought it was still ok and not blown. But now I know to have both sides light up on the test light when checking fuses... I hate diagnosing electricals.... I'd take mechanical problems over electrical problems any day🤣. Drove the car around my suburb with the engine up to operating temp and it runs fine like before. However, I notice that my fuel pressure is still at 49psi. So I'm thinking this must be normal for my system as I've upgraded the stock fuel pump to a Walbro 255L/h with a constant 12v mod.  But anyway, I'm just glad to have my daily back on the road! Thanks everyone for the replies on this thread, all sorted now! One thing I want to ask you tuner guys, my base fuel pressure on the haltech main settings are set to 43.5psi from default (my tuner must have not checked the fuel pressure maybe when tuning my car?). Do I set it to what it actually is idling on at 49psi? Or just leave it ("if it aint broke, don't fix it/leave it")?  
    • The max they would go for me is 50.
    • That cannot have been a fun set of drilling. The stock "baffle" looks identical to rb26, I just cut fuel cell foam to fit the full length under the baffle.
    • I understand your sarcastic exasperation. But to be fair - the baffles do indeed fit OEM cam covers. They did omit to say that you need to do a bunch of stuff. But they do fit them.
×
×
  • Create New...