Jump to content
SAU Community

Recommended Posts

  • Replies 45
  • Created
  • Last Reply

Top Posters In This Topic

Top Posters In This Topic

Posted Images

also, I'm not sure what type of tyres you have, but if they are cheapies then for sure they would have contributed to this incident. having good tyres is so important. they are the only link to the road and there is no point having great suspension, or good brakes or good power if you then slap on some nexen/nangkang/wanli tyres on it. yes good tyres are crazy expensive but the safety of you and your family and other people on the road make them well worthwhile.

Thanks DIF and Cassbo..

Actually talked about this later that night.. one of these days my partner is gonna take me out for a bit of defensive driving .. he did a course a while back..

I wish I had known to just take my foot off the accelerator but unfortunately it all comes down to my inexperience as a driver.. I think we may be getting a shitter just for me to drive around to gain more experience before I drive the Skyline again.. you know when I look back I think I pushed harder on the accelerator as I lost control because I did a full 180.. I've learnt that lesson the hard way..

Hiya Beer Baron I'm not sure about the tyres.. but I suspected that my wheel alignment was a little off before the incident.. silly me thought I could leave it for a little while because it didn't seem that bad.. just goes to show hey..

I can't even tell what tyres you have on there.. But if you are on a budget I would highly recommend a set of Federals SS595 they are in the cheaper bracket very affordable and they are great tyres.. Too soft for the track but perfect street tyres if you are on a budget or have a family.

I've had this set on my car for over a year now and have done a few trackdays and driver training/ skidpans on them and they have held up very well.

I can't even tell what tyres you have on there.. But if you are on a budget I would highly recommend a set of Federals SS595 they are in the cheaper bracket very affordable and they are great tyres.. Too soft for the track but perfect street tyres if you are on a budget or have a family.

Do they sell them at any tyre shop? Like bob jane? How much were they roughly?

Thanks heaps DIF.. because we are on a very tight budget.. still need to do 100k service on both our cars.. now coz I've stuffed the tyre and alignment and whatnot that's another few hundred.. not to mention new rims..

100k can be expensive depending on what you need can sometimes cost up to $600 +

I have 34GTX rims on my car at the moment which are 225-35-16 (I think) and I paid around $147 a tyre.

The only places that do sell Feds are Payless tyres and ABC tyres I'm not sure if anyone else does but my advice will be to shop around for the right price. They might have the dealers on their website if you have a look..

lol..

OK well it turns out to be the lower suspension sub frame.. trying to source out parts.. anyone know of any other places to get parts.. hopefully in the hills shire.. blacktown area? even parramatta.. ..

hey Cassbo.. where is SSS located.. do u happen to have their phone number? I've looked it up and there are quiet a few companies called SSS.. there's SSS automotive imports.. SSS and mechanical .. SSS auto parts.. which one? :teehee:

Cheers ;)

talk to mark at hills motorsport, at the back of the complex at 2a victoria ave castle hill. he will have all the stuff you need in stock.

but it wont be the whole sub frame, just lower control arm and/or tie rod

hey Cassbo.. where is SSS located.. do u happen to have their phone number? I've looked it up and there are quiet a few companies called SSS.. there's SSS automotive imports.. SSS and mechanical .. SSS auto parts.. which one? :teehee:

Cheers :)

SSS Automotive

(02) 9896 6111 or (02) 9636 4301

Unit 6, 120 Gilba Road, Girraween

I suggest taking in the bent parts for identification purposes. I had to go there twice because I picked up a driver's side lower control arm instead of a passenger side one. Wasn't a massive problem, just an easy swap, but it did involve driving there and back twice.

Be careful there though, there are plenty of shiny things in there that will tempt you to spend more than you need to ;)

Cassbo,is that damage to your smic or just a warp in the photograph?

it is indeed real.... although if I hadn't of seen it in real life I would of sworn he did some magic with the photo :)

Pm replied also Anna... :P

hey Jeffworld2.. not yet.. need to find a subframe for the 34.. I'm sure that's what my uncle was talking about (he had a look at it lastnight).. because he said it wasn't the control arms.. just the lower suspension frame so I'm assuming it's the whole frame.. for the rear suspension..?

dad's gonna call me back.. it's actually at my parents house in Glenwood (hills area).. while I'm here in Mount Annan without my poor baby.. wonder how she's holding..

Thanks a heap for all the help.. thanks Duncan, anna, matt, jeff, george... we'll call around.. i'll just confirm with my uncle as to which part it is we need.. then we can get the ball rolling...

WILL KEEP YOU UPDATED!

cheers :thumbsup:

AH, it's been pissing down here, so we've been seeing a heap of people in the same predicament :) Not cool for you, I hope you can get it all fixed up no hassels :)

Defensive driver training is invaluable, and skidpan is actually so much fun that everytime it rains, you're gonna deliberately want to kick it out :( I kid you not! If you're trainers in Syd are anything like ours here, you'll get your ass kicked if you just 'take your foot off the accelerator'. The point of defensive driving is to learn how avoid as much damage with as little effort as possible, in the case of a slide, continuing with it, but steering through it safely, to miss obstacles & get yourself straight again. If you take your foot off, all you'll do is regain grip, and you don't want that while you're steering!! :thumbsup: Anyway they're a tonne of fun, you'll thoroughly enjoy yourself.

Not sure about where you guys get your federals down there, but all the Jax Quickfit stores here have a deal with the Qld supplier, you might find they have the same deal there :) Anyway it's worth trying!

Let's hope it's just the alignment :D

Anna.

hello again.. you guys were right.. it was actually the lower right suspension arm that was bent.. dad went down to sss in Girraween to pick up the part today... hopefully it's the right one..

Uncle is fixing it on thursday hopefully.. and she'll be back on the rd by the weekend *fingers crossed*...

HOLY POO ANOTHER ANNA!!!.. Anna's must love Skylines.. :) I know I do..

Yerr will stick to partner teaching me for the mean time.. then when I get the confidence I might check it out.. but atm I don't think we can afford to do any damage to our cars.. we have three young kiddies.. anyone wanna buy any of them.. they're good kids.. not very picky.. our oldest loves fast cars and Skylines.. and they help out around the house.. goodlooking kids too.. any takers??? :D

Be careful there though, there are plenty of shiny things in there that will tempt you to spend more than you need to :D

AHAHAHAHA .. me dad went cause it's only 15mins from where they live.. temptation avoided.. :)

Good luck with the repairs,

Let me know if you need any genuine parts new from Japan, all I need is you to Pm me your car's Japanese VIN and the parts you need,

I work at a car dealership with Nissan parts department and I can get a discount.

I was recently up for some new rotors, castor rods and front control arms for my r34 as my current ones were worn and the difference in price to retail was pretty substantial.

Hope it works out!

Suspension is all fixed :D ... getting 4 new rims and tyres fitted today.. turns out both rims at the rear were damaged .. the rear left was damaged on the inside...

Can't wait.. getting the car back tomorrow :)..

Thanks for all the help guys.. I'm so glad there are lots of people here willing to lend out a helping hand!

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Rear doors central locking wiring removed and cleaned. See the first 8sec video of when it’s filled with river silt. its a snip of what I’m up against. front and rear doors complete now. Maybe another day removing carpet and bits and pieces. Then the re assembly begins. 🤙 att.DqweJqhY5MZiZYQDVMhn3LtvdD1RBZ7TBG4f2s7W1zM.mp4 att.lFuN22MZEowqCbFAXoDw009r2gHL76ChMVfxMfBX-uk.mp4
    • There aren't boost creep issues, it's not engineered around the restriction of the cats but if you haven't tuned the engine a full decat + exhaust can flow enough air to run off the end of the OEM load scales and you will get a pretty substantial reduction in ignition timing as a result. I recommend using DFCO, avoiding ignition cut limiters, and avoiding popcorn tunes along with running a cat unless you enjoy a perpetually soot-covered and potentially burnt bumper.
    • Small update, it's been slow moving over the Christmas period with money having to go everywhere thats not my car 😅. I got myself a little present to myself from "santa" in the form of some tidy radiator mounts from fitmint automotive to get rid of the stock ones that look like they have been in an accident before and then straightened by a caveman. I know I should've replaced the rubber bush at the same time but I had no idea how bad they were until I was replacing the mounts. Decided to order their dash mat while I was at it as I feel like I am lucky enough to have a pretty decent condition dash and I don't want to risk it being ruined while it's parked in the aussie sun while I'm at work. I have found another electrical fault to add to the evergrowing list to eventually chase down. Every time I replace my taillight globe it blows within a day of use, I'm starting to think my life would be easier if I took a few minutes to learn how to use  a multimeter 😂.   Had some luck with finding a series 2 drivers headlight on marketplace to replace my mismatched series 1 headlight, a subtle difference but it's nice to have a matching set of lights now.   I returned to the air con problem due to being sick of this summer heat, found a good condition condenser to replace my leaking one! I got it in the car and was happy when I got the thumbs up that the system was now holding gas. Sadly the compressor is not kicking in for some reason, we even tried branching the relay in the fuse box. I have tried to do some research on the issue with no clear understanding of what the fix is, so for now it will be placed on the backburner until I can be bothered to look into the wiring to the compressor. The last small mods I have done was cutting the horizontal vents out of the front bar, not really in a functional airflow sense but I just think it looks better as I am not a fan of the series 2 bar. I also switched the shift knob out for a hosoboyo aluminium grex style one, it has a really nice more direct driving feel than the outdated rubbery oem one. Thirdly, I chucked on one of the ebay bonnet strut kits. The fitment is decent and they seem to work fairly well. They have only given out once while the car was parked facing downhill, I think if I was working under the bonnet I would still put the oem hood stay up to be precautionary as to avoid getting a speedy concussion.
    • Got pneumonia, haven’t played with her in a while, but I’m back now. Previous owners cut bonnet pins into the bonnet. My choice try find a replacement or spend $15 get some pins myself to cover up. Now only one small hole to cover. looks shit now, but when the bonnet is red again. Be good 🤞
    • No R32 GTSt had 15" wheels. 205/55-16 was standard GTSt fare. 4.36:1 is standard R32 turbo auto diff. I think the manual was too, not 4.11. 4.11 and 4.08 were R33 namual and auto respectively.
×
×
  • Create New...