Jump to content
SAU Community

18 Ft Nerues Boat

mid life crisis
 Share

Recommended Posts

mid life crisis Veteran

mid life crisis

Posted
Posted

gee i dont know where to start but due to a back injury thats not going to get any better and is deteriorating rapidly i reluctanty place my 18 ft nerues on the market .

ok it;s a 18 ft runabout with the motor mounted on a pod the amount of fishing room in this boat is amazing . the motor is a cv yammie 115 hp ie it is a premix motor that i actually prefer cause at least when i mix the fuel up i know the oil is in there .

i am the second owner and the boat has spend it;s life under cover in a shed since new it has done just over 500 hrs since new both boat and motor . it comes complete with canopy and clip on side clears / 90 litre under floor fuel tank / 2 huge under floor storage area's.

all saftey gear lifejackets / epirb/ flares/ gps with lots of pt huges snapper and whiting marks left in it / colour sounder / v sheet/ torch / hf 27 meg marine radio and also vhf marine radio/ comes with a muir electric anchor winch about 1400 bucks to replace /custom made alloy bait board .

boat has full night lights navigation and cabin .

the 2 heavy duty marine batteries where replaced at christmas and have done just 2 trips there is a battery isolater switch to select either of the batteries or both at the same time .

there is a water trap fuel filter in line from the tank to the motor

the boat is in quite good condition and is a clean tidy unit .

the trailer is a single axle dunbier that i have modified and it tows great will sit on a 100ks behind a falcon wagon and we towed it down to edithburg on many occasions. it has been fitted with new disc brakes as documendet on fish sa when i was doing it and the same time i lenghened and reinforced the draw bar .

there is a electric winch to pull the boat onto the trailer its a bit slow but does the job the trailer is drive on but ive never been game to try it lol .

the trailer has 3 brand new 8ply light truck tryes with the spare mounted and locked onto the trailer . the trailer has just had new marine waterproof lights fitted to it

ok for this gem i want $24.500.oo i am not interested in trading smaller boats due to my back injury and im not in a hurry to sell it for much less than that i know there hard to find in clean condition cause i looked far and wide till i found this one

i can be contacted thru here or you can ring me most times on my mobile 0402 258352 if you would like to arrange a viewing or just have any further questions

regards squidley aka dean

http://s290.photobucket.com/albums/ll262/squidley_photo/ i will endevour to get some better pics when im well enough to get the boat out of the shed

Link to comment
https://www.sau.com.au/forums/topic/222579-18-ft-nerues-boat/
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • RB335
      C-red tuning?

      By RB335 · Posted

      Seemed to be good when Jeff owned it but they did a shit job on my car, probably worth a think before spending 10's of thousands of dollars where they might be cutting corners
    • Rezz
      DeAgostini 1/8 scale BNR32 Nissan Skyline GT-R Nismo

      By Rezz · Posted

      Starting with issues 1 - 5, we have already run into a problem...!  Issue #4 contained 2x front brake calipers, instead of 1 caliper and 1x steering knuckle. Will have to call DeAgostini on Monday to sort it out. Anyway here's some photos.  Issue #1 is the front bumper, headlights and number plate. Issue #2 is the front wheel (with "We produced with spartan air." text on the centre cap!) and tyre, the front lip spoiler and cylinder head cover with ignition coils under the centre cover... which will never be seen again. Issue #3 is the bonnet and cylinder head. Issue #4 is the front strut, brake disc (with laser etched metal discs) and brake caliper. I stopped here because of the issue with the missing steering knuckle.  Next update will be #5 - #10 in a few weeks.
    • Rezz
      DeAgostini 1/8 scale BNR32 Nissan Skyline GT-R Nismo

      By Rezz · Posted

      DeAgostini is one of a few companies that release quite large (the largest commonly available size actually) 1/8 scale models in a series of weekly issues over 100 - 110 instalments.  They release different models for different markets and DeAgostini Japan have release the BNR32 Skyline GT-R Nismo last month. I've made two of these 1/8 scale sized cars (one an R35 GT-R from 2012 - 2014, the other I'm just about halfway through, a BNR34 Skyline GT-R from the 2Fast 2Furious movie) so when this R32 was announced there was no way I could ignore it as it's my favourite out of all Nissans.  Each issue costs around $20 so it costs about $2.2K when completed. I suppose it is very expensive for what it is, but the quality and details are really very good, and there are many "gimmicks" like fully functioning exterior and interior lights operated with a remote control, working steering, all doors/bonnet/boot/fuel lid open and close, the side mirrors fold in and it even has a speaker for the engine revving sounds when you turn the lights on.  Each issue comes with a magazine that tells the story of the BNR32 Skyline GT-R Nismo from the first design stages of the BNR32 to Group A homologation and the various racing version that were run in the Japanese Group A and JGTC, and Australian Group A.  So I plan to update the build in this thread 5 issues at a time.  https://deagostini.jp/r32/?srsltid=AfmBOooKjxDc4EUK2rmXqMBPgyHfFJ24s4oEPJBNpnF-lFlsRoW0PE6P
    • Predator1
      Billet Merge Collector for manifold

      By Predator1 · Posted

      As per title.. has anyone used so far? Keen to hear results, comparisons. In the market for a new mani for my new turbo. Any issues cracking?
    • MBS206
      Help Understand GTT Boost Setup

      By MBS206 · Posted

      Re read everything that has been written about this in this thread.. Let us know if you're still confused.
×
×
  • Create New...