Jump to content
SAU Community

Recommended Posts

C'mon you're all a pretty creative bunch

Give me some ideas for my GTR using the top two combinations (sorry, I'm not into paying thousands for plates) to keep it around the $500 mark.

http://www.ppq.com.au/CreateAPlate.aspx

Link to comment
https://www.sau.com.au/forums/topic/223423-httpwwwppqcomaucreateaplateaspx/
Share on other sites

I have seen "TI3VOM" and "PMS 247"

How about - 60J1RA "Go ji ra"

The only one which falls into the $400-500 category is PMS247 and I don't think Mark would drive it with those on :banana: btw, its taken

I came up with MYTR. Its not cheap, but: Mightier, MY GTR. Its available, but yeh they reckon about $2300.

GTR320 is available and cheaper too.

Thats all I have.

Edited by datto260Z

I got

280BHP - if you feel like keeping your gtr stock...unless that is too late then forget that...

26LTT - 2.6L twin turbo

ZLA26 - Godzila 2.6L

NFS32 - Need for speed 32...

NYA32 - Only if you like cats ^^

Thats all i got, i go bed now...refers to time posted.... ><

I got

280BHP - if you feel like keeping your gtr stock...unless that is too late then forget that...

26LTT - 2.6L twin turbo

ZLA26 - Godzila 2.6L

NFS32 - Need for speed 32...

NYA32 - Only if you like cats ^^

Thats all i got, i go bed now...refers to time posted.... ><

good effort, it must be the late night that did it :P

I've ordered my plate, didn't end up getting any I had on my shortlist which were

32FTW or UNQ32

although I did like ZLR32 I decided in the end I really wanted GTR in it, couldn't get the numbers after I wanted so settled for this one.

post-28428-1213911527.gif

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Latest Posts

    • Hey lads just finished tidying up a gtr a bought. Originally from Sydney now living in New Zealand 
    • Hi Guys, Looking for this piece if anyone can help out.   https://tfaspeed.com/products/nissan-skyline-r33-gtr-rear-trunk-finsher-panel
    • How did you go with your problem? End up fixing it. Have a y34 aswell vq30det
    • But if I smoke test 5th cylinder it’s all ok, no leaks  when I try with 2nd it’s leaking exhaust and intake, it doesn’t come from oil dip stick.    so maybe when car was running poorly, rich or sth. Spark plugs were black and covered in charcoal or sth lookalike. could potential contamination make valves not seal properly? is there also a possibility that rb’s don’t have equal performing cooling passages  meaning back of the engine will be hotter than front. Can this cause improper wear if engine was running under load for short time? Or carbon build up could just burnt from 4-6 and is still on 1-3?   I out of my head like really. Timing is as manual crank-exhaust 47, exhaust-intake 38 at this point I thinking about give it a try and make another 500-1000km and check if anything change, if not I will most likely disassemble engine head /or whole engine and send it back to rebuild. It’s killing me     
    • Thanks Duncan, I don't have a GTR these days mate. Gone soft..
×
×
  • Create New...