Jump to content
SAU Community

Na Loom

Caza

By Caza,
in Engines & Forced Induction

 Share

Recommended Posts

nizmonut Community Regular

nizmonut

Posted
Posted

different as in injectors coils and sensors plugs or different as in ecu dash board plug end?

depends on the year it was made, there were differences between the 89 to 93 R32 looms and sensors, may be best to swap all the sensors over aswell.

Link to comment
https://www.sau.com.au/forums/topic/223892-na-loom/#findComment-3943515
Share on other sites
Caza Enthusiast

Caza

Posted
  • Author
Posted

yeah its different at the ecu end aswell as the afm plug would na coil packs work aswell cos the igniter pack is different on the laurel loom compared to the na loom and also has the same problem with the crank angle sensor aswell as the tps

im pissed why did they make the laurel looms soooo different compared to r32?

Link to comment
https://www.sau.com.au/forums/topic/223892-na-loom/#findComment-3943630
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • MBS206
      Shoota's R33 GT-R RB30/26

      By MBS206 · Posted

      Probably a smart choice to buy one vs build, purely for the motivation part as you said! Imagine the metal dust everywhere from grinding all the steel to build one. Ha ha ha!   Also, post a photo of your garage.   Mine is below, this is where I've been cleaning and have already half filled a caged 6*4 trailer. And this is after my cleaning expedition mentioned previously... The middle normally has a car in it, but I'm dumping things in the middle as I sort through them. And poor skyline was dusty and has had the lightest few drops of rain and now it looks atrocious and needs to be dragged back out and washed thoroughly! And yes to the right is technically another bay, you really can only see 2 bays out of 3 in this picture.  
    • joshuaho96
      HKS stroker kit step 0/1 or HKS GTIII 2530

      By joshuaho96 · Posted

      It's more like on average the things I see a lot of things going wrong. Yes, usually the people who reach out are the ones who are having problems but on average it feels like mechanics and tuners here aren't really competent. I swing between thinking my standards are just way too high and wondering whether people really are just this dumb. I just had the strangest 10+ reply argument on a Facebook group over someone insisting that the factory R34 GTT boost control solenoid reduces boost pressure to 5 psi when it's on and raises boost pressure to 7 psi when it's off despite showing the exact plumbing in the factory service manual and the solenoid behavior detailed in the FSM.
    • dyl33
      Cleaning my wheels 😍

      By dyl33 · Posted

      I steam cleaned my near new set of volk gtc wheels 14 years ago and farrkkked them lol. The clear coat cracked like spider webbing in several areas. Lesson learnt don't do that. 😭
    • Dose Pipe Sutututu
      R34 GTT idle problem

      By Dose Pipe Sutututu · Posted

      If you don't touch the CAS, then you're fine.
    • GTSBoy
      Cleaning my wheels 😍

      By GTSBoy · Posted

      Yeah, my moulds and seals are 32 years old now. I think I will continue to not use a pressure washer on it.
×
×
  • Create New...