Jump to content
SAU Community

Recommended Posts

  • 3 weeks later...

Oh the old 510 , check out adam carolla in usa he has some of the bob sharp 510's and races vintage in california

I had a 1200 coupe ( half dozen of them over the years) but wanted a 2 dr 510 so bad , they all ended up as race cars lol

Spotted a nanna spec rolla the other day i wanted to follow her home to buy it haha 2 dr even bet it had less then 10,000km on it perfect nick

as always josh, looks tops

cant wait to see it in action up the Mile

heres mine, causing some controversy now with my new rims :P

cage is nearly done (just needs the rear section notched and welded in), boot floor being prepped for fuel cell + fuel pumps, motor is about a week off being ready (tops), then its put it all back together and wire in the Haltech

425863_2976702648871_1000982751_32668484_278229451_n.jpg

424861_2976701248836_1000982751_32668483_457962819_n.jpg

Gonna make it to alma matty ?

Yeah, we'll be fine. Once everything gets back its a matter of putting it all together. Saving the week leading up to Mt Alma to be doing last minute fixes and the tune

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • I have one and it was at ~43.5PSI.
    • Put a pressure gauge on the fuel rail.
    • I've uploaded logs / the current map to Gdrive if anyone has any ideas. https://drive.google.com/drive/folders/1FPnr22Z-EilG7tYdHSi0Qb07P2jfFLKV?usp=sharing
    • I'm running a Haltech Platinum Pro with the stock map for the RB20DET + tweaks for my build. When I started it this morning, the IAT was at 32F/0C (Outside temp was ~42F) and the AFRs went off the scale for my AEM gauge. I let it run for ~30 seconds then turned it off. I then did a smoke test, by hooking into a vacuum line directly behind the throttle body, and confirmed there was no leaks ( i let the smoke tester run for ~5 minutes / confirmed it was generating smoke before hand ). I then started the car again, after fixing a power steering leak.... and it seemed to be happy for ~30 seconds (was at ~11/12), but then seemingly shot back up to ~18 again. I then let the car run for a few minutes, thinking this was just cold start related, but the AFRs never came back down. I didn't let the car fully warm up, so maybe this makes sense, but I'm not sure what to do? The AFRs, when I last ran it, were normal, but because of personal reasons I haven't been able to break in the car. It was rebuilt last year. Engine / Mod list: Supertec pistons Spool rods Kelford 270 cams and Springs Stock crank Deatschwerks 900cc injectors Walbro 255 (Wired directly to the battery relocated in the trunk) NKG Audi R8 Coil packs + Conversion Harnesses from Wiring Specialties Holset HY35 turbo Haltech Platinum Pro ECU Haltech boost controller (wired in for high boost RB25 Neo transmission + needed bits for the speedo to work  
×
×
  • Create New...