How do I install a Turbo Gauge ???

[rogueman]

Guys,

I've bought an aftermarket turbo gauge and have already installed it to the pillar. I've wired up the lights, but not too sure on how to wired it up to the turbo....HELP!!!

[Lippo]

Do you mean boost gauge?

[rogueman]

yep....the turbo boost gauge.

[Zombie]

T it off the fuel pressure reg at the front of the intake manifold.

Or find a workshop to do it, if you have put most of the gauge in apart from the vacuum hose, it shouldnt cost too much.

Adam

[rogueman]

Thanks alot for that! I know exactly what ya mean...

;-)

[predator]

Best to start in the engine bay..as zombie describes rig a T-piece (would have probably been supplied with the guage) to your fuel pressure reg.. Attach the tubing to a straightened out coathanger with some plastic tape.. Shove the coathanger through the firewall at rubber grommet. Get into cabin, find where tubing has come through... feed through, run up side of dash and connect to boost guage.

[hippy]

how do u install it to a gauge on the piller .. i mean if u run the hose up to the pillar then u have to make a hole in the piller for it correct?? which would mean u have to butcher it cause u can't squeeze it anywhere else you will screw up the reading .. ??