Jump to content
SAU Community

Recommended Posts

Don't think it will remove the boost cut - because I think they don't have one.

thanks for the reply

installing my front mount upped boost to 10psi, after puting in a boost tee i had fuel cut with any increase above 10psi thought that might have been ecu over boost protection, but maybe its something else.

maybe aftermarket ecu is my only choice.

thanks again :(

Link to comment
https://www.sau.com.au/forums/topic/227482-r32gts4-remap/#findComment-4004463
Share on other sites

I would pm CEF11E or drdrift. CEF11E is in Melbourne but he does do r32 remaps, and your 32 ecu would need a cradle put in etc. He does do tunes without dyno time as well. Think he was charging around 150$

i have a pre programmed eprom by some company called marobi, only cost $15

wasnt going to put it in but maybe it can solve my problems.

think its a bit dodge though as not tuned on my car

Link to comment
https://www.sau.com.au/forums/topic/227482-r32gts4-remap/#findComment-4004646
Share on other sites

Have a chat to cef11e or drdrift, if your not happy with your current remap, as they both have a fair bit of experience, I have one in my car, any only reason I need to change it is due to having a boost leak when the car was dynoed. Ceff11e has done countless r32 remaps now.

Link to comment
https://www.sau.com.au/forums/topic/227482-r32gts4-remap/#findComment-4004663
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Latest Posts

    • So there is no other way to remove and install the ball joints then to buy the Frenchys kit?
    • Just to close off this post with the cause of my oil consumption issues. Vertical scoring and glazing at the bottom of cylinder 6. I'm not happy, but at least I finally found something. I'll pull it and get it apart asap. Hopefully I don't need to go one size up in piston. 
    • I finally got around to purchasing an actual articulating borescope. Great tool to have, I've been very impressed vs my old regular inspection camera.  With that being said, sadly I finally found the cause for my oil consumption. I always had the feeling something wasn't right but compression and leak down tests were always perfect and I had already inspected the cylinders. This time i dropped each cylinder to its absolute lowest point and with the better quality camera I found this... Bottom of cylinder 6.  Scoring looks deep and I'm presuming oil getting by caused the glazing. I already spoke with my assembler, and will be dropping it off as soon as I can pull the motor and get it apart. I'm just hoping it's not deep enough to require boring out from 86.5 ->87mm. Pistons aren't cheap. 
    • I think it's the same. It all comes from the same shithole refinieries in SE Asia.
    • I was referring to the final octane level achieved once 10% ratio of ethanol is added.
×
×
  • Create New...