Jump to content
SAU Community

Recommended Posts

For those of you who don't know i just picked up series 2 1999 stagea it came with adjustable teins not quite sure which model yet but while the compliancer was doing the roady he found the rear shocks were seized and could not be adjusted the car is stupid low in the front but have been adjusted up to legal but the rear sits lower now cos of no adjustment . I was wondering anywhere in melbourne to get these repaired or can i buy tein rear only from somewhere? Any help greatly appreciated.

Link to comment
https://www.sau.com.au/forums/topic/228062-seized-teins/
Share on other sites

Thanx for the directions guys found a tein authorised repairer 40 km's from my house which is f$%kin rare when your in central vic, but then again bendigo is the hoon capital of Victoria more cars seized under the new hoon laws than anywhere else in vic not bad cosidering they have a population smaller than geelong. :)

Link to comment
https://www.sau.com.au/forums/topic/228062-seized-teins/#findComment-4013580
Share on other sites

so the shocks aren't seized, it's just the height adjustment?

Any mechanic with half a clue and a set of C spanners should be able to sort it if he has some decent penetrating oil or a big enough hammer.

Yeah just the hieght adjustment part of it

That was my thought but APPARENTLY they will not budge obviously they dont have enough wd40 and big enough hammers in their workshop LOL :)

Link to comment
https://www.sau.com.au/forums/topic/228062-seized-teins/#findComment-4013662
Share on other sites

Well A)I cant get them out myself B) It needs to be done for roadworthy and the compliance shop cant do it. So in order for me to pass roady and get plates the height of the rear needs to be lifted since the jap owner had it stupid low and now it's seized in that position which is about 80mm of the ground.

Link to comment
https://www.sau.com.au/forums/topic/228062-seized-teins/#findComment-4016757
Share on other sites

Well A)I cant get them out myself B) It needs to be done for roadworthy and the compliance shop cant do it. So in order for me to pass roady and get plates the height of the rear needs to be lifted since the jap owner had it stupid low and now it's seized in that position which is about 80mm of the ground.

If its just for roadworthy you've probably got more chance taking the springs out of the car and working on them.

My compliance shop was going to throw away my Ohlins coilovers (ie. >16 way adjustable and good spring rates) because they told me they were "rusted out" (sand blasting fixed the surface rust).

Link to comment
https://www.sau.com.au/forums/topic/228062-seized-teins/#findComment-4018343
Share on other sites

im not sure which state u are in, but height adjustable shocks that allow u to lower the car below stock are against ADR's, they are not legal but u might be able to engineer them which counts for something in some states.

also not to mention the spring rates, im not 100% on this but i beleive u can only increase the spring rate by 75%, im sure someone can correct me if that figure isnt right. AFAIK the teins are a touch below this, even the aus spec ones.

Link to comment
https://www.sau.com.au/forums/topic/228062-seized-teins/#findComment-4022030
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • One other question, is there a chance that changing the idle speed can lead you down a rabbit hole and is the reason the tuner didn't touch it? Reason I ask is because if that's the reason the tuner avoided it then I probably shouldn't be touching it lol.
    • Pfft. As if I'd ever point a high pressure washer at my car.
    • The nature of my commute has changed. Way back then it was traffic lights all the way, for ~28km. It sucked. When they finally stitched the expressway together I could do a good 15+km of it at a steady 80-100 with no stopping. That alone has gotten me down to flat 10s. Prior to that it was mid-high 10s. I can't remember the delta that I saw when I got the idle down. It was only ~150 rpm, because the idle speed was never terrible, but for the delta in consumption to be noticeable it would have had to have been at least 0.2-0.3 L/100km - which is not to be sneezed at when it comes for absolute free. It's only about 50L per year, but that's ~$100. A few extra pizzas is always welcome. Note that I have a record of every tank of fuel that has ever gone through my car except for a handful put in by someone else, like my mechanic. I can show you the difference between stock RB20 and tuned RB20, stock RB5Neo and tuned, winter and summer fuel blends, winter and summer fuel blends when the ambient temperature is not appropriate for the blend, working O2 sensor, blown O2 sensor, boosting f**k out of it and frightened to boost it because it is pinging, and so on. OK, I probably can't do all that now with 100% clarity - but at the time when any of those things were in event, you could see it in the records. There's 25+ years of simple tank after tank records, so you have to look for landmarks to work out approximately how old any single record is. What's really important is the meta data and that lives in my head.
    • If you're claiming the issues are not skyline specific, then either the USA is living in the 90s / early 2000s, OR you have the issue of "survivor bias". Which is you're mainly hearing and listening to those with terrible experiences, and haven't found the guys who have cars with good decent builds and no problems. It happens in AU too, that plenty of people keep having issues, and they keep going to the workshops that are known to be shit "because I read on the internet". Even worse, are those who keep posting on the internet as though they know for a fact what something is, when they've never touched/looked at said item in their life, and again are making assumptions, based on something they read, or because it's a certain way in other cars. It's even funnier when those same people debate the facts with the people who've lived and breathed this stuff for over 15 years. Example, I've had someone tell me you can't do something with a Skyline, because they read it on the internet, except I can tell they're wrong, as I did that exact thing back in 2008 with my Skyline.
    • The funniest part I saw, was someone would bitch and moan on FB about something, Andy would be the one to respond, asking for more info, if he could contact them, what the engine setup is, what their config file was, and 95% of the responses were people just going "der! It doesn't work" and Andy going "What doesn't work?" And then going "The firmware!" And they'd go around in circles as no one could ever give information, and Haltech couldn't fault things on the bench, (especially when people wouldn't give any specifics).   Many moons ago, when Andy was back at e420c stage, he reached out to me, and asked me to test different plug and play looms for him (already had an e420c in the car on his V1 PNP loom). And he kept asking me, as I was competent enough to be able to give him some specific feedback on what was/wasn't working, how to replicate the faults etc, and work through things with him. Most people are terrible at answering the questions they're asked, or being able to provide quality feedback other than "it doesn't work".
×
×
  • Create New...