Jump to content
SAU Community

Recommended Posts

  • Replies 177
  • Created
  • Last Reply

Top Posters In This Topic

ay rhys didnt know u got a rine!

GM is poo

I think iv decided I might go the 25 route, I mean my car has a bit of gear on it and any 33 that I buy for 10K is going to be ex east and stock and probably screwed.. so I might save up some money, buy a halfcut and do a full rebuild on the motor before it goes in the car.

he said he wanted something with more power then the rb20 and was looking at the rb25, and said he doesnt have enough money for a gtr so what makes everyone think he could spend thousands on all these crazy engine conversion ideas lol?

Funny thing is I like it how everyone says every man and his dog has a R33 But I hate to say it R32's are f@rken everywhere now. So I wouldnt say that any more.

but yer throw RB25 in, I think thats what the R32's needed all along, GTR proves that :wave:

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • does anyone know tie rod torque setting and anti roll bar for r34? Is there a workshop which shows various components torque setting?
    • Hi    have purchased pair of eibach wheel spacer as I couldn’t fit set of wheels I bought for my car due to it catching caliper.   I know I need to cut the bolts on my discs so they sit flush with the nut supplied but the nut doesn’t sit all the way into the groove meaning wheel would not directly fit onto the spacer rather the nuts. Any thoughts?   See pic   https://ibb.co/VJK5w5G
    • Nah. There's not shit tonnes of pressure in there. Just drill with a 1.5mm drill or something equally tiny. When the drill goes all the way through thee gas will start to come out, but with such tiny path through the flutes of the drill bit, it won't be at all dangerous. You can be as paranoid as you like from then on. I'd just pull the drill out while keeping my face out of the line of fire. But then, I spend half my time looking into pressurised furnaces. So my risk acceptance is somewhat higher than most!
    • Been needing a new clutch for a while, but holding off because of life tingz and adulting. But... Being of Asian descent, I can't pass on a good sale, especially everyone else is selling it for $2k+ (JJR has it for $1799). Really on the fence on this one, because the unsprung version of this is $1281 via Shitbox (Sparesbox) and the sprung version is quite a bit more (no idea why Shitbox doesn't offer them). Ending up just sending it and getting the twin sprung organic. Mainly because I wanted the car to be nice to drive and didn't want to make it more of a shitbox than it already is.    
    • It was the pressure I was worried about. @GTSBoy does drilling them pose any problems?
×
×
  • Create New...