Jump to content
SAU Community

Recommended Posts

Just got the car back from a big-ish service incl all oils changed, fuel filters, gapped spark plugs etc and noticed that if I rev the engine and hold rpm somewhere between 1500 and 2500 rpm (I didn't try higher because I didn't want to attract attention to myself..) while the car is sitting idle in neutral, there's a muffled popping sound followed by a small shake (drive seat shakes noticably) every few seconds ..sometimes more than one in a row.

Like popcorn starting to pop ..just more muffled sound, and each pop shakes the car a bit. Is this just the exhaust note or should I be worried ? Detonation? Car's ecu was tuned before the service and it was NOT pinging/detonating...

The car's an R34 GTT with a turbo-back exhaust with a 3" catback (HKS SilentPower)

I never noticed this before but then again I never held the engine at 1500rpm for a few seconds before either..

Link to comment
https://www.sau.com.au/forums/topic/231130-popping-sound-and-car-shaking/
Share on other sites

hm are you sure this is missfire? I searched for "Popping" last night and read a lot of older discussions and a lot of people seem to be under the impression that these popping sounds are normal on skylines and a few said it's probably due to running rich in that rev range .. no mentions of missfire anywhere.

I have no idea which plugs they put in ... I'm taking the car back to unigroup to have a listen to this. Could it be due to old fuel? car's been at the shop for was 2 weeks and only 1/4 of tank of fuel sitting in it

Edited by Delta Force

mine runs rough in the same situation. though in mine i put it down to section of the map thats never been tuned.

It's just a rich miss and nothing to be overly concerned about. It's something tune related and i wouldn't expect it's a result of a service. I'm pretty sure unigroup will tell you the same thing but it doesn't hurt to have it looked at if you are concerned.

Took it back to unigroup and as soon as Yavuz heard the popping at idle and low revs he said "yep it's misfiring" .. and that it's due to the small gap (0.75mm) so they regapped the spark plugs to 1mm and no more misfire/popping sounds ;-) Best of all ..they did it all for free! That's good service. Cheers.

Took it back to unigroup and as soon as Yavuz heard the popping at idle and low revs he said "yep it's misfiring" .. and that it's due to the small gap (0.75mm) so they regapped the spark plugs to 1mm and no more misfire/popping sounds ;-) Best of all ..they did it all for free! That's good service. Cheers.

Hey mate was yours the black r34 there? I was there about a week ago also.. had a safc tune. Mine is doing the same thing and yavuz said its normal with running small gapped plugs.. Funny i also hear it pop every now and then only on idle

just one thing ... Yav also mentioned that the car may misfire at higher rpms with bigger gap (and non stock boost). But for me that's not really an issue as a very rarely go above 4000rpm anyway (daily driver)

  • 3 years later...

sorry to bring up an old thread but i think my input is relevant and not worth starting a new thread.......

i have been experiencing the same muffled popping/rumble sound then shaking when car is idling after cold start. i noticed the rumble and shaking start to settle down after the engine oil had warmed up to about 90 degrees.

couldn't figure out what was wrong, then 2 weeks later the check engine light came. it turned out an exhaust leak at the rear muffler was causing the rumble and shake while idling.

the leak was at the weld joints along the exhaust pipe that had started to rust. this was probably making the car run a little too rich as well, but i could be wrong.

cheers!!!

mine does it too at idle, is normal. atm mine has a dump pipe like 6 inches long and is running Super rich so it sounds worse, gaps are .8. is perfect when you apply any throttle though all the way to 7000rpm

mine does it too at idle, is not dangerous. atm mine has a dump pipe like 6 inches long and is running Super rich so it sounds worse, gaps are .8. is perfect when you apply any throttle though all the way to 7000rpm

ah crap that effort to edit a post was ABSOLUTE FAIL

Edited by PaulosECR33

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Hey lads, reviving an old thread.  As an update, since the last time replied to this thread, ive done mostly suspension. Havent touched the motor except for maintenance. Though upon changing spark plugs, found out i had splitfires pre-installed! Updates: - Got me some stock airbox top cover and snorkel to fit onto the original intake. Should be free of defects - Bought a set of R34 GT-T brakes (not installed yet, going to rebuild + respray in champion blue + white 'Nissan' text) - Bought the last set of bilsteins from @Sydneykid and had them installed. Has been making some sounds on the rear but hopefully should be sorted out after this New Year break. - Regreased front caster rod bushings (poly bushes..) - Rear upper camber arms - Whiteline sway bars (BNF27Z 22mm + BNR11XXZ 24mm).  The rear sway bars are a bit short (ive read 50mm else where) but was still able to get them in.  Anyhows, I reckon suspension is sorted now. Maybe replace bushes (do have a set of front upper control arms from SK not installed yet) but should be okay for now. From now, I'm wanting to start working on the motor, drivetrain etc etc. Still debating on the order to go on and what to buy etc but: - ECU ( Haltech or Link ( Link states that it dont support A/T or AWD functions... Can anyone attest to this? ) - Highflow turbo ( ATR43ss2 ) - Intercooler ( Not decided yet, but cant find many good afoordable ones. Toshi says to opt for crossflow Japanese. Bit difficult this one, unless I get a returnflow Blitz from JJ? ) - Injectors ( Any recommendations ? I do have a nismo FPR ( Thanks SK ) ) - Seats - Tune by either Toshi or DVS To be fair, I did consider just keeping the stock turbo and nistuning it. Sat in a mates stock N, that had something like 200kw, and I reckon that felt more than enough. Maybe I should just go this route ahhaha. Too many choices.... Planning a trip down south, so wanting to just clean things up and make sure it gets to and from in one piece. Anything else specifically I should do before ? Cheers lads  
    • Must be for the car’s lucky charm 🤷🏽‍♂️ She runs fine, but it just seems to take about 1L less. Maybe I’ll have the oil sump dropped at some point to check if there is anything 
    • Hmmm interesting. Mine is the exact same and clearly the right one.  The mystery of the engine oil being full after 3.5-4L continues 
    • Yes I as well would like to find out where I could get some of the seat material with the red or blue small squares in it
×
×
  • Create New...