Oil Gallery Restrictors

[xsv_32]

I got two tomei restrictors and fitted them to the block and they are a crush fit item so i was expecting some excess metal but once they were in the holes seem to be burred over a little so that they appear smaller than before i fitted them. Did i f**k it up or do they do this normally? Shoud a try deburr the holes or remove them? ANy advice would be awesome.

[r33_racer]

have you actually measured them? or is this an eye measurement your going on? Grab your verniers and check that the hole is 1.5mm.

[xsv_32]

Umm not a measured thing, but the difference is noticeable by eye...

[Sydneykid]

You should only be using one oil flow restrictor with the other oil feed blocked off.

Cheers

Gary

[Cubes]

Perfectly normal. Clean it up with a Stanley blade and SK's your uncle.