Intercooler's Size For An R33 Gts-t Serie 1

[Nick378]

Hi guys, i'm new to this forum. First of all, i'm one of your old brother from Montreal (North America).

I'm about to buy an intercooler, probably from garrett and i want to know wich size i have to pick. I do have an aftermarket bumber.

Is 24" length, 10,3" height and 3,5 " of depth ok?

I'll make the piping similar to the blitz style.

http://www.skylinesaustralia.com/forums/in...t&id=125287

By the way this is the car.

http://photos-400.ll.facebook.com/photos-l...764016_3656.jpg

This intercooler will be added with an garrett gt3076r, i don't know if it changes something for the size..

Edited August 14, 2008 by Nick378

[W0rp3D]

that seems about the same size as my blitz, how much power are you looking for?

Unsure how much power this set up will hold since it uses the factory piping in the engine bay which is 2.25", the rest of the blitz piping is 2.75" but you would get away with 2.5" since it is limited by the engine bay size of 2.25".

[Nick378]

that seems about the same size as my blitz, how much power are you looking for?

Unsure how much power this set up will hold since it uses the factory piping in the engine bay which is 2.25", the rest of the blitz piping is 2.75" but you would get away with 2.5" since it is limited by the engine bay size of 2.25".

i'm looking for 400-450 hp. But if i have to, i'll change to whole piping.

[W0rp3D]

Going to be very hard to get 2x2.5 inch pipes up through the guard and keep the air box, even if you go a pod there wont be much room left.

Have you maybe looked at getting a forward facing plenum, that way you can run the piping either side, saw a pic some where of the intake side piping running under the rad support so you did not have to cut a hole in the guard.