Jump to content
SAU Community

Recommended Posts

guys i was in full throttle into 3rd when i herd a massive bang and lost almost all power...

when i put my foot down it chockes and will only jump a little while it goes up the vacum line on my boost gauge (which it does exeptionally fast) as soon as it hit boost it just goes no where.

clearly i am thinking the turbo is blown since there is no flutter and will not show and boost on the gauge as well as heaps of smoke comming out of the exause

but why wont it idle properly or drive properly or even go over 2000rpm before chocking. i thought if i blew the turbo it would drive as a non turbo would??

Link to comment
https://www.sau.com.au/forums/topic/233442-blown-r33-turbo/
Share on other sites

most likely yoiu have blown a turbo. And it will run like crap. Some cases it would run like a non turbo. other cases it would feel like no matter how hard u try the car wont move much at all.

pull off the intake pipe leading to the turbo (rubber) and have a look at the comp wheel

Edited by R33GOD
Link to comment
https://www.sau.com.au/forums/topic/233442-blown-r33-turbo/#findComment-4092752
Share on other sites

The reason it may not idle properly is most likely due to the Oil from your turbo going through the motor and fouling your plugs...

As far as not going over 2000rpm without 'choking', I don't know what you exactly mean by 'choking' though could be in safe mod which I doubt so I would say it is just way to rich and getting bugger all spark.

Take it to a workshop mate. There are plenty of them in sydney and won't cost much to get them to have a look and diagnose whats wrong.

Link to comment
https://www.sau.com.au/forums/topic/233442-blown-r33-turbo/#findComment-4092879
Share on other sites

good thing i checked the cooler piping before ordering a new turbo!! the cooler piping just under the airbox had blown where it meets the stock piping but only to the side and not entirely off so it was still running but terribly and not boosting. i reconnected the pipping and the idoling returned to normal and the black smoke stopped after a few seconds. i took it for a drive and its boosting but ht ecar is sluggish and miss fireing. i am guessing this is because the spark plugs are in ruins after flooding the engine so much and so many times????? so i will buy a new set of them and see she returns to her boosting best

Link to comment
https://www.sau.com.au/forums/topic/233442-blown-r33-turbo/#findComment-4095209
Share on other sites

i've had both these problems, i have blown cooler pipes off (when i just bought my rb20 silvia) the guys hadn't put them on poperly this makes the car choke and stall when trying to move it. This afternoon, the turbo actually blew and i knew it was going to at some point as i was an idiot, i had no boost controll running for the turbo (usually watched the gauge) and no bov running. Was going to put on a bov n attach a bleed type boost controller but now i can't! ahh but yes ur problem is definatly a blown turbo, i'd say the exhaust wheel is blown bad luck, hame!

JUST READ LAST POST OPPZ!

Edited by H@ME
Link to comment
https://www.sau.com.au/forums/topic/233442-blown-r33-turbo/#findComment-4095422
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • I don’t really have any ideas how to set the timing on the CAS 😂, sounds like the top, sounds like it maybe misfiring as well as ticking,  got the box sorted 😌, must of been a air bubble on the clutch side
    • Use a 2' length of hose (that's 2 foot, not 2 inches) as a stethoscope to localise the source of the ticking. From cam covers? From exhaust or turbo manifold gasket? From injectors? From lower down in the engine? Etc. Use a timing light to set the timing. Put Redline Lightweight Shockproof in the box. It's not the very best thing for the box, but it will take a box that refuses to engage a gear with other oil, and make it engage a gear. I had to put it in when I installed the R33 box I have in my car. It would not select ANY gear when running. Smurf jizz made it work. That was >10 years ago and I still use it. I'm stuck with it now. Failing that - rebuild the box.
    • Well done Duncan. The fuel tank bulkhead lid is also in great condition (some of mine were stuffed). These are now out of production and good ones like that are becoming hard to come by.
    • Wow that's a steal, you've done well there. 
    • Exterior LEDs R34 2Dr R34 4Dr Position Lamp T10 T10 Winker front T20S T20S side T10 T10 rear T20S S25S150 Anti-hyfla relay TYPE3 TYPE3 tail T10 T20W Stop Lamps T20W T20W High Mount T16 T16 back T16 T20S number T10 T10 trunk T10 T10 Interior LED Item No.     Map Lamp BA9S single-sided     Room Lamps T10×31     Trunk Lamp T10     meter Early T6.5 pedestal     final T6.5 pedestal     NISMO T6.5 pedestal     Liquid crystal section T6.5 pedestal     Winker T6.5 pedestal     High Beam T6.5 pedestal     3 SERIES METER Early T6.5 pedestal     final T6.5 pedestal     NISMO T6.5 pedestal     air conditioner Early Liquid Crystal T3     Late LCD T4.2 Short     button T4.2 Middle     Hazard SW T3 Pedestal Short     Keyring T5     Cigar Socket T5
×
×
  • Create New...