Jump to content
SAU Community

Recommended Posts

  • Replies 93
  • Created
  • Last Reply

Top Posters In This Topic

lol was gonna ask you to move it over one before the 300zx got there. but thats just rude, your parked, your settled, petrols a bitch, next time i'll get the photot done :devil:

haha shoulda just asked man it wouldn't have been a problem :cool:

was a good night tho

now people start to realise why Nick goes over that side more than stays around this side of town :)

and nick you only come over to the east to see me :closedeyes:

ok sweet as, so west meet tonight at 7.30pm at watergardens car wash accross image auto? lol

see ya all tonight!! :closedeyes:

-Ferah

theres a meet tonight? i'm down for that shieet!! coming straight after work.

maybe post it up in the vic forum so other people will know.

and the cops are not as bad over there as they are over our way!

It was a bit unusual that there wasnt that many cops about on the prinny hwy. Usually if the weather was like it was on fri, the hwy is crawling with them!!

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • Welp, too late already committed to the cam cover breathers to be welded on. I did think about adding a catch can in line with the drivers side sump breather as a phase 2 along with a drain to the sump on the original catch can but with an inline ball valve so I can have it closed if needed.    Likely a single breather would have been enough but I think I’m overcompensating to hopefully not have to empty my catch can and clean up oil over flow every session.    out of curiosity has anyone actually measured crank case pressure before and after various mods? I’m considering adding a sensor for science 
    • Is it a dog or synchro box? I guess either way, if it is new and crunching in one gear only, it has to come out and go back to the shop to check/measure as there is either an assembly or manufacturing issue
    • These are small points I should actually add to my original post. GKtech makes an extended slave line for this conversion. It's what I use, and it works well. You'll also need a CD009 slave cylinder.  S/R Chassis Z33/Z34 Conversion braided clutch line As for transmission sensors, you'll need to both extend the wiring and replace the connectors. I can't recall which is which, but one is your neutral switch and the other the reverse switch. As they are just switches, just test for continuity with your transmission in neutral or reverse to figure out which is which. Connectors:  VQ35 neutral Switch Connector | Wiring Specialties VQ35 Reverse Switch Connector | Wiring Specialties 
    • I’ll try and see it could be the release bearing. As for the 4th gear grind maybe clutch doesn’t disengage properly cause it is slightly like very slightly hard to go into first could be due to the slab cylinder pin being short uni clutch is a twin plate.   Ive attached some assembly photos hopefully you can open the link and see maybe detect what’s wrong https://share.icloud.com/photos/0dc2YvW__Hl6jl-l2_0jejjpg https://share.icloud.com/photos/09e0jkWOK-vP48c1cfY6u3ViA https://share.icloud.com/photos/0b4rDmh5R7pK7fb1VtND73a3g https://share.icloud.com/photos/05eeUi_6dC4DVi80jOUYDgb0g https://share.icloud.com/photos/06335TgY1XxyIJal_wkdQLhzw
    • Yeah for sure that is peddle adjustment 
×
×
  • Create New...