Jump to content
SAU Community

Recommended Posts

  • Replies 43
  • Created
  • Last Reply

Top Posters In This Topic

Top Posters In This Topic

Posted Images

i just went and checked... and i found that resistor....but it is already pluged in... so it can't be that.... the plug i am trying to find a home for is the same plug as the one the one that plugs into the resistor though...

bugger....

i just went and checked... and i found that resistor....but it is already pluged in... so it can't be that.... the plug i am trying to find a home for is the same plug as the one the one that plugs into the resistor though...

bugger....

and the colour of the wires that go to it are pale green and a blue one

have you check to make sure u have a positve feed to the coils, an earth and pulse feed from igniter.

i have done yes, i have tested for earth on the coilpack plug (all is good) and the test light flashes when i connect it to the poitive side of the coilpack plug (when i crank the motor over)

in the manual i have, it says to connect the multimeter to earth and the other lead to the middle wire on the coilpack plug.... but it does'nt tell me what the multimeter should read?...

should be. under crank just make sure you don't have a voltage drop on the earth side. get ya multimeter and select voltage and connect one lead to the earth on the battery and the other to the engine. you should not see anything greater then .5volt...... also check the positive side of the coil under crank to make sure you don't have a voltage drop. under crank you'll expect to see the voltage drop to 10volts at the battery and no less at the coils.

i don't think it's a computer problem as he has an injector pulse and pulse to the coils. the cas sends a pulse to the computer and the computer outputs to the coils and injectors.

true but its worth a try wouldnt ya think. just plug and play

and lets not 4get he went through how many batteries.....

Edited by skylinekid

ok all plugs accounted for

cranks over fine now, good oil pressure.

still no spark though, checked earth wires etc., i have a multimeter handy if some one can tell me how to test the colipack plugs and ignightor properly and what readings i should get etc.

not alot of gtr's down here still, so i cant really swap ecu's etc.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



×
×
  • Create New...