Jump to content
SAU Community

Recommended Posts

Make: Nissan

Model: Skyline R32

Milage:13****

Transmission:Manual

Colour:Mazda 3 Blue

Location:Brisbane

Complied?Yes

RWC supplied?Yes

Currently registered? Yes

Price:$12,500

Contact:Brett - 0402854163

Comments / Modifications:Custom Paintjob Mazda 3 Blue

Rb25 engine conversion

Body Kit

Hks FMIC (125mm thick)

Greddy Alum. Radiator

3 inch turbo back exhaust

Upgraded fuel pump (not sure what but very loud)

Boost a water temp Greddy Guages.

Splitfire Coilpacks

Nismo Clutch

Custom Plates

Rego runs out in November so it will come with 6 months rego

Images:post-1491-1222928036_thumb.jpgpost-1491-1222928054_thumb.jpg

Edited by bretto
Link to comment
https://www.sau.com.au/forums/topic/238601-r32-gtst/
Share on other sites

  • 2 weeks later...
  • 3 weeks later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • I have one and it was at ~43.5PSI.
    • Put a pressure gauge on the fuel rail.
    • I've uploaded logs / the current map to Gdrive if anyone has any ideas. https://drive.google.com/drive/folders/1FPnr22Z-EilG7tYdHSi0Qb07P2jfFLKV?usp=sharing
    • I'm running a Haltech Platinum Pro with the stock map for the RB20DET + tweaks for my build. When I started it this morning, the IAT was at 32F/0C (Outside temp was ~42F) and the AFRs went off the scale for my AEM gauge. I let it run for ~30 seconds then turned it off. I then did a smoke test, by hooking into a vacuum line directly behind the throttle body, and confirmed there was no leaks ( i let the smoke tester run for ~5 minutes / confirmed it was generating smoke before hand ). I then started the car again, after fixing a power steering leak.... and it seemed to be happy for ~30 seconds (was at ~11/12), but then seemingly shot back up to ~18 again. I then let the car run for a few minutes, thinking this was just cold start related, but the AFRs never came back down. I didn't let the car fully warm up, so maybe this makes sense, but I'm not sure what to do? The AFRs, when I last ran it, were normal, but because of personal reasons I haven't been able to break in the car. It was rebuilt last year. Engine / Mod list: Supertec pistons Spool rods Kelford 270 cams and Springs Stock crank Deatschwerks 900cc injectors Walbro 255 (Wired directly to the battery relocated in the trunk) NKG Audi R8 Coil packs + Conversion Harnesses from Wiring Specialties Holset HY35 turbo Haltech Platinum Pro ECU Haltech boost controller (wired in for high boost RB25 Neo transmission + needed bits for the speedo to work  
×
×
  • Create New...