Jump to content
SAU Community

Recommended Posts

Hi im just wondering if anyone can tell me if the front shocks on a RS-V(rwd) are the same as any other cars, so far i've established that the rears are the same as r33 gtst - eye at the bottom - but the fronts are different, and most of the threads here are all regarding the awd stageas

Link to comment
https://www.sau.com.au/forums/topic/239017-what-shocks-for-rs-v-rwd-front-end/
Share on other sites

Hi im just wondering if anyone can tell me if the front shocks on a RS-V(rwd) are the same as any other cars, so far i've established that the rears are the same as r33 gtst - eye at the bottom - but the fronts are different, and most of the threads here are all regarding the awd stageas

I would've thought they'd be the same as AWD stageas - ie. r33gtr front, and stagea-specific rear. Note that whilst the rear shocks have the same fitting as gtst shocks, they are not the same. To put it another way, whilst the gtst shocks will fit, they will not provide the correct support for a wagon.

Pretty sure r33gtr shocks on the front are the go however :)

Yup what GorGasm said. i just got a set of WGC34 specific coilovers from japan. The rears are the same as the AWD but the fronts are very different due to there being less weight and not having to avoid a drive shaft.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Is it a dog or synchro box? I guess either way, if it is new and crunching in one gear only, it has to come out and go back to the shop to check/measure as there is either an assembly or manufacturing issue
    • These are small points I should actually add to my original post. GKtech makes an extended slave line for this conversion. It's what I use, and it works well. You'll also need a CD009 slave cylinder.  S/R Chassis Z33/Z34 Conversion braided clutch line As for transmission sensors, you'll need to both extend the wiring and replace the connectors. I can't recall which is which, but one is your neutral switch and the other the reverse switch. As they are just switches, just test for continuity with your transmission in neutral or reverse to figure out which is which. Connectors:  VQ35 neutral Switch Connector | Wiring Specialties VQ35 Reverse Switch Connector | Wiring Specialties 
    • I’ll try and see it could be the release bearing. As for the 4th gear grind maybe clutch doesn’t disengage properly cause it is slightly like very slightly hard to go into first could be due to the slab cylinder pin being short uni clutch is a twin plate.   Ive attached some assembly photos hopefully you can open the link and see maybe detect what’s wrong https://share.icloud.com/photos/0dc2YvW__Hl6jl-l2_0jejjpg https://share.icloud.com/photos/09e0jkWOK-vP48c1cfY6u3ViA https://share.icloud.com/photos/0b4rDmh5R7pK7fb1VtND73a3g https://share.icloud.com/photos/05eeUi_6dC4DVi80jOUYDgb0g https://share.icloud.com/photos/06335TgY1XxyIJal_wkdQLhzw
    • Yeah for sure that is peddle adjustment 
    • What are your thoughts on this after having it for a while, worth getting?
×
×
  • Create New...