Jump to content
SAU Community

Recommended Posts

I have read the thread talking about a small flat spot and I have a similar problem but on a larger scale!

When the engine is under any kind of load the car flat spots like crazy! The first thing i tried was to change the plugs but that did not work, so the next thing for me to do is check the coil packs...

I was wondering about the best way the single out faulty ones in the set? Or if any body else has any idea as to what this might be!

NOTE: I dont think it is the fuel maps ( Flats spots a way to big)

& I dont think it is the cam timming ( had someone have a look at it)

Any comments would be helpfull, thanks guys....

Link to comment
https://www.sau.com.au/forums/topic/23922-savage-flat-spots/
Share on other sites

Mate, this is true, i had exactly the same problem, its all fuel, when you turn the boost up, it dumps more fuel in, it needs to be leaned out. I had a slight miss on 7psi, (checked everything) then went to 10psi and it was useless. Everytime i booted it, and as it revved, it coughed , farted, backfired. You should see my dyno graph.

Put an SAFC in and it has done wonders, and so much more power.

Link to comment
https://www.sau.com.au/forums/topic/23922-savage-flat-spots/#findComment-511706
Share on other sites

Fuelling issue.. could be your fuel pump is dying. Get that checked out.. or at least the pressure in your fuel system is at the correct pressure under load.

Apparently to test the fuel pump squeeze the fuel line before it enters the rail. If the engine cuts out with only a little finger pressure its on its way out.

Link to comment
https://www.sau.com.au/forums/topic/23922-savage-flat-spots/#findComment-511790
Share on other sites

this happened to me when my 32 came back from the 'mechanics'...

Check your intake plumbing. Make sure a hose hasn't come loose at all, and that all the clamps are doing their job. Basically as my 32 hit 7+lb it would overfuel like a bitch and drown the engine. the more boost, the slower it went.

Just my 2c but good luck...

Link to comment
https://www.sau.com.au/forums/topic/23922-savage-flat-spots/#findComment-520376
Share on other sites

All though fuel is a problem in r33's because of the fuel dump at 4500 rpm due to the ecu ajusting for the duel stage stock boost controller, I dont think this is the source of the multiple flatting...

I say this because my car ran fine ( with a small flat at 4500) for about 3.5 months. Then all of a sudden the super flatting started!

This leads me to think that the problem is one of the following:

(thanks to all the posts above!)

1)AFM

2)coil pack

3)ignition pack

4)spark plugs & gap ( not the case because i have changed them over twise)

5)fuel pump and or filter

6)timming (long shot!!!)

Thanks again to all who helped with suggestions!!!

Any other suggestions will allways be helpfull.

Link to comment
https://www.sau.com.au/forums/topic/23922-savage-flat-spots/#findComment-521411
Share on other sites

I had the same problem with multiple flatting at higher than standard boost. Mine was fixed by putting colder plugs in. I know you've checked the plugs and assuming you put the same plugs in as the original ones you had, then this probably won't help. But I do know how frustrating it is trying to track the problem so I thought I'd mention it.

Link to comment
https://www.sau.com.au/forums/topic/23922-savage-flat-spots/#findComment-522678
Share on other sites

Yea, its very frustrating and I think everybody who tunes there skyline past stock probably goes through the same thing!

I was running shit sparkies which led me to think that they were the weak spot. But I now run NGK Iridium's and i was under the impression that these are quiet good, am i on the right track here?

Link to comment
https://www.sau.com.au/forums/topic/23922-savage-flat-spots/#findComment-522686
Share on other sites

I'll start by letting you know I'm an accountant, not a mechanic, but Iridiums are supposed to be very good.

I had platinums put in mine when I bought the car and had this flat spotting problem when I increased the boost. It would get worse if I gave the car a hard time (engine gets hotter).

Plugs have a heat rating and I think spark at a different temperature depending on their rating. When I replaced the plugs with colder ones, the flat spotting went away.

Perhaps get a second opinion though as I don't want to give you the bum steer. Plugs aren't cheap.

Link to comment
https://www.sau.com.au/forums/topic/23922-savage-flat-spots/#findComment-522697
Share on other sites

Its not spark, me think its still fuel, i changed plugs and it didnt do anything. As soon as i upped the boost, it got worse so i would to run stock boost, even then it wasnt good as it got warmer.

Get an SAFC, lean the fuel out. When you increase boost more fuel is dumped in, simple.

Link to comment
https://www.sau.com.au/forums/topic/23922-savage-flat-spots/#findComment-522827
Share on other sites

fuel is the easy one to check - get a $40 power run done at ur local dyno and check the AF curve.

its spark which can be a prick to find, and you never know it could just be a dodgey connection somewhere in the ignition wiring, these cars are getting on 10 years old now and with intense heat its easy for connections to corrode

Link to comment
https://www.sau.com.au/forums/topic/23922-savage-flat-spots/#findComment-523659
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Last year I got a set of MCA street coilovers for my turbo Forester after my son hitting a concrete gutter/wall on a small bridge causing the whole drivers side suspension to get bent because the rain just made the car slide out I love them, I think they were $2400. even had a hiccup of have the wrong hub configuration (my fault) so got onto MCA and they sent the correct shock ends overnight parts from QLD, for free!  I was very impressed with their customer service and quality of the product  
    • They've had some weird failures on their brake actuators. One of them was because they added some kind of lubricant to the factory fill brake fluid that aftermarket brake fluid didn't have so it would affect the seals. Another was just mysterious, probably internal corrosion or something eating away at Prius brake actuators. Parts alone for those are a few thousand USD so not a cheap fix.
    • Selling a genuine Nissan Skyline R33 Coupe 8-Pin Power Window Master Switch Part No. 25401-26U10 Price $300   IMPUL Gear Knob – Rare JDM Upgrade Upgrade your interior with this genuine IMPUL gear knob – a rare and stylish addition to any JDM build. Premium quality, perfect fit, and an authentic Japanese touch for your ride.  Price:$300 Nissan Skyline R33 (Series 2) Sedan Tail Lights Immaculate Condition OEM JDM S2 a pair of OEM Skyline R33 Series 2 sedan tail lights in excellent condition. These are becoming harder to find, especially in this state. Price:$900   Located in Melbourne (Western Suburbs) – Shipping available Australia wide at buyer’s expense. DM if you need anymore details.  
    • KYBs are typically twin tube, putting them in the lower tier of desireability. Do you just want to replace worn out ones for the lowest cost? I mean, you wouldn't just replace one end of a car, if the rears are a similar age to the fronts, then they are probably nowhere near what they should be, and likely won't be great against brand new fronts. So, to spend ~$800 on 2nd tier dampers, when you could get a decent set of MCA coilovers for <$4k.....? As to the strut tops. 1st up, the Sparesbox site specifically tells you that they are not correct for an R33. Beyond that, why do you think you need them?
    • That's not very Toyota of the Toyota!
×
×
  • Create New...