Jump to content
SAU Community

Recommended Posts

  • 4 weeks later...

Any major fuel supplier or car company behind E85 can only be a good thing as far as availability goes :D Even if it is....Caltex.

By the way guys, cars do ping on E85, it's just that the sound is not your typical distinctive high pitched rattle that we're used to hearing, rather a very deep thumping noise - far harder to pickup for the untrained ear.

Got my 33 tuned on E85 on Friday with a gt3040 (0.63) rear.

On 98 it (14psi) made 227rwkw and on E85 we wound it up to 18psi and made 252rwkw but gained around 30-35rwkw through the midrange.

Feels more responsive down low but doesn't feel like it hits as hard.

My 555cc injectors are at almost 90% so don't have much more room

I will post up dyno sheet soon.

Got my 33 tuned on E85 on Friday with a gt3040 (0.63) rear.

On 98 it (14psi) made 227rwkw and on E85 we wound it up to 18psi and made 252rwkw but gained around 30-35rwkw through the midrange.

Feels more responsive down low but doesn't feel like it hits as hard.

My 555cc injectors are at almost 90% so don't have much more room

I will post up dyno sheet soon.

Get a 0.82 housing.

"Feels more responsive down low but doesn't feel like it hits as hard." This is exactly right, if a turbo is more responsive and has more power/torque down low it wont feel like it hits as hard. Hitting hard is a sharp change in torque. It will be a lot faster with more low down grunt so it just depends on what you prefer.

Got my 33 tuned on E85 on Friday with a gt3040 (0.63) rear.

On 98 it (14psi) made 227rwkw and on E85 we wound it up to 18psi and made 252rwkw but gained around 30-35rwkw through the midrange.

Feels more responsive down low but doesn't feel like it hits as hard.

My 555cc injectors are at almost 90% so don't have much more room

I will post up dyno sheet soon.

something's not right.... my 555's are on 92% @ 323rwkw in an RB25 running e85

^^^^ Yes i was looking at yours the other day and realised something is not right with mine. Even the initial 227kw seemed very low as i'm sure it made around 240 last time.

Do you know roughly how much extra timing you were able to run? Also did you keep pulling fuel out until it started losing power?

i think the reason for the lack of power aswell as the high injector duty is a very restrictive exhaust side. change to a .82 or 1.06 housing and make sure your exhaust isnt too restrictive

yep, my .63 rear (or near enough, probably a little small, OP6) makes 290rwkw on E85 (740cc injectors)

Hamish, your rear housing is a smiliar sized judging on the boost curve, and it makes oodles or power as well.

don't know the exact specs of the gt3040 though...

Afternoon all,

I've been following this topic and looking forward to seeing this fuel at the pump in QLD, whenever that may be....... I came across this article today about biofuels and thought I'd share it with all.

Hey Guiltoy, how's it feel to be 2years ahead of the US Military?

http://www.smartplanet.com/business/blog/s...-biofuels/6274/

"A U.S. Navy-owned F/A-18 Super Hornet is the first supersonic jet with afterburners to fly on a biofuels blend."

Do you think i should drop the exhaust next time?

I still dont get the duty cycle being so high (hit 92% yesterday) with 550 injectors and i presume a good pump.

if you are getting any sort of restriction i would always drop the exhaust and do a run... it costs nothing and helps problem solve at worst

The absolute reality of the situation is that any major retail fuel supplier will dick around with the percentage of ethanol in the mix. I don't even think it'll be called E85 at the pump. Probably 'high ethanol unleaded' or similar.

Whether an argument for a seasonal mix exists in Australia (I don't believe it does), the fact of the matter is that fuel companies will use the cost of ethanol at any given time and their ability to vary the ethanol content to leverage the wholesale cost of unleaded petrol.

In short, the mix will almost certainly change between 70% to 85% without warning and you won't know when or where.

The absolute reality of the situation is that any major retail fuel supplier will dick around with the percentage of ethanol in the mix. I don't even think it'll be called E85 at the pump. Probably 'high ethanol unleaded' or similar.

Whether an argument for a seasonal mix exists in Australia (I don't believe it does), the fact of the matter is that fuel companies will use the cost of ethanol at any given time and their ability to vary the ethanol content to leverage the wholesale cost of unleaded petrol.

In short, the mix will almost certainly change between 70% to 85% without warning and you won't know when or where.

= danger.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Way more than 1cm. Appreciate the advice maybe I try changing the bushing first
    • IMG_8641.mov     She doesn’t sound the best but starts with out using any gas now. I just ran some injector cleaner through her. started roughly the first time after adding it but gave it the beans slowly upto 4k, Must have cleaned a few cobwebs out. another step in the right direction for the sub
    • Sadly I can confirm if you are actually seeking to drift, you will quite easily spin up one wheel. Even if you're going in a straight line. I am not entirely sure of the metrics/terminology here but there's only a certain amount that the helical will actually spin both wheels. I've seen it on video with my own car where two lines of smoke switch over to just one after you really get in to it. Unlike with a clutch diff where you can keep your foot planted until the car regains grip, in my experience with the helical you want to be utilizing traction control allowing LIMITED slip or lifting (partially) when you start to spin up both tyres with a Nissan helical. Which makes them pretty sub optimal for drifting duty. That said... this is probably a helical on numbers alone. Just put the Kazz in
    • Let's just fix the problem by f**king the rest of the gearbox.
    • Unlikely, as per Greg's post. This is not helical diff behaviour unless one wheel is up off the ground. Shimming what? You don't "shim" a mechanical LSD. Probably not in the sense that you have heard of people "shimming" a diff. And the process that Nissan f**kwits call "shimming" a diff involves super-preloading a VLSD cartridge against the side of the diff to create a friction/wear point (in a place that it wasn't supposed to have one) to make the sloppy, useless, viscous diff into a hybrid viscous/mech abortion. In case it isn't clear, I consider the process to be stupid. Nike.
×
×
  • Create New...