Jump to content
SAU Community

Recommended Posts

I lost my key for my locknuts recently and need to get them off, apart from the "hammer socket onto nut" trick to get em off, anything easier? I don't mind getting new nuts but since they're really deep inside the wheel (Volk Challenge F-zero), getting a socket in there is going to be tough.

Any recomendations? Most tyre places would be able to solve my problem right?

Link to comment
https://www.sau.com.au/forums/topic/239491-lock-nuts/
Share on other sites

Can't weld, the nuts are inside a hollow in the wheel that is about 5 cm deep.

Bridgestone Magil eh? Might go there for a tyre rotation and free lock nut removal :banana:

Hmm should still be able to get the electrode in there if you know someone with an arc welder. But if you can get it for free even better!

Link to comment
https://www.sau.com.au/forums/topic/239491-lock-nuts/#findComment-4184321
Share on other sites

Can't weld, the nuts are inside a hollow in the wheel that is about 5 cm deep.

Bridgestone Magil eh? Might go there for a tyre rotation and free lock nut removal :(

just ask them if they can do a favour for you :kiss:

removed all of my mates ones and if your paying them for a tyre rotation then they should do it for free :P

Link to comment
https://www.sau.com.au/forums/topic/239491-lock-nuts/#findComment-4184469
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Sharing results from recent Liberty Walk R35 GTR, since they are still considered as somesort of a V36 Skyline. We do them turbos too. This are high flowed SS-1 models with ball bearing conversion done.  Car have managed to pull 485awkws @ 20Psi so far pushing limitations of factory built engine. The build list for R35 GTR enthusiasts as follow : HyperGear high flowed stock turbos in SS1 (G25-660 specs) Custom titanium intake pipes. Vspec performance titanium front pipes. Vspec performance 4" titanium exhaust. Upgrade fuel pumps. 1200cc injectors. Ignition coilpacks Hks intake plenum. Hks intercooler piping. Greddy intercooler. Greddy bovs. Top-secret coolant reservoir. Emtron ecu. Straight E85. Built gear box.  
    • Nah no bearings, just slip fit.  Would be a reasonably challenging but not impossible job to modify it to run bearings but I'm hoping that's not necessary as I may have well built one myself if I end up spending hours modifying it!
    • Brumbys with good shells are bloody expensive, I've looked at 2 "cheaper" cars, and walked away from both,  plus after some research spare parts are fairly sparce I'm starting to think that I missed the boat on finding a clean one that is straight (ish) and without alot rust I'm starting to think about a old Hilux as panels and other parts are much more available as they sold tens of thousands of them I use to be indecisive but now I'm not sure
    • A Brumby would probably fit a big metal toolbox in the back... this is how it begins  
    • Picked up a new OEM boot seal for the MX5 today as the old one got ripped a bit by me being a idiot by seeing if I could fit a large metal tool box in it, it didn't fit, and ripped the seal with the corner of the tool box I am still waiting on time to get the cams and new balancer installed, as well as the repairs to the boot Time will not be an issue soon though
×
×
  • Create New...