Jump to content
SAU Community

Recommended Posts

Hey guys, well today i was letting my fiance drive the skyline (which was a big mistake...) but yea she had left teh handbrake on and tried to take off in first which it looked like she was trying to power lanch with boost lol, i have this clutch smell now which i now she did burn the clutch a little, but the car drives fine and changes perfectly and smoothly, i just got this smell every once in a while this only has happened in the last 5 hours so will the smell go away?????

Link to comment
Share on other sites

if you can't make the clutch slip with a typical high-rev then full throttle change up through the gears, i wouldn't worry about it (assuming it didn't do that in the first place)

Link to comment
Share on other sites

hey mate

had a funny smell a couple of nights ago, didnt go away and i end up taking it out for a 2hour drive to gelong an back, didnt seem to have a problem.

a day later, my mechanic and i took it for a drive and it slipped all over the place, its now shot!

hope you dont have the same problem, just take it easy for a little while i reckon.

Gezza

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share



  • Similar Content

  • Latest Posts

    • That's true. However, this problem has started since the tuning. First time with the return journey from the tuning. But yes, the pipe was clogged with dirt and rust. That was certainly due to age
    • Great info @tidi0x  Will definitely be handy for others and maybe me if I decide to keep the shit box H pattern.
    • Bumping this up one last time.... I wanted to follow up on the clutch slave issue. I realized that what the issue comes down to is the pocket is flat milled, and the cylinder does not want rest flat. So in order to mount it correctly you will need to make a spacer for the fingers so the cylinder is floating. I took two plates of aluminum, drilled some holes and was good. I did still need to make the relief cuts in the bell housing, as even with the spacer the bleed section still interferes. The OE bell housing the mounting holes are raised from the housing.       
    • If the event in USA goes ahead will be interesting as it seems the rules will get more cars over here. Apparently the track is laguna seca too. Yeah s15, if I get a the lower dash trims, centre console and change front cross member to standard LCA position will fit clubsprint. See how rules are as i would rather do complete widebody than a bolt on flare to run the 295 with proper clearance.
    • If the car is legal height I can't see it being an issue. Found a thread on reddit that might offer some insight.   I got a ticket from a copper in QLD for my S15 being too low. They had this wheel thing on a stick that they put under the car and it hit my exhaust. Anyhow went to an exhaust shop to get the exhaust tucked up/hung a little higher and I wound the coilovers up a smidge. Don't think I even had to go back to the police station unlike when I got defected for having a carbon bonnet when I brought the S15 from the ACT to QLD and had to replace it and then rock up at a police station and have a yougish female officer who knew nothing about cars confirm that I had changed bonnets. Should have just painted the carbon bonnet yellow to match the rest of the car lol
×
×
  • Create New...