Limits Rb20de+t

[clip14]

Has anyone pushed the limits of a rb20de+t?

There are plenty of people here in NZ pushing well over 300rwkw on rb25de+t setup's with stock internals (completely unopened).

Not much experience i can find here of rb20de+t setup's though.

or if anyone has any comparative photos of rb20de rods vs rb20det rods, or bearing specs etc

i know the higher compression will mean closer attention to tuning is required, but there are many 10:1 compression turbo setup's running high numbers reliably

Thanks

[gfunkk]

general rule is +t conversion's dont like heaps of boost

i'd be interested to see what a rb20de+t can do since rb20det has such shit power/torque down low

[clip14]

that is a general rule. I've seen plenty of 10:1 compression sr20de+t setups running 1bar (15psi), and up to 18psi

with good fuel and good tuning, a cool intake charge, you can run decent boost numbers on high compression engine.

[monga]

You could make 500hp but it might last 12 minutes, what you want is a reliable balance were its going to last a reasonable amount of time before letting go. AD4M over here in WA made 400~HP on one unopened and was fine for ages before letting go.

So maybe 250rwkw is fairly safe with supporting mods and tune.

[clip14]

thanks for the reply. I'm only looking to ever push 200rwkw on the rb20de+t, maybe 230 if it won't lag too much

would you be able to get more details about this rb20de+t from WA?

mods? dyno sheets?

[monga]

I'm not exact, but it was a TRUST TD06 all major supporting mods with EMS 8860. Ran 12.1 also.

[bubba]

AD4M's motor was an RB20DET I'm pretty sure, not an RB20DE+T.

Tezzah on here is running an RB20DE+T but only has a 25 turbo on there.

[DE+T]

i just finished my rb25de+t shes been chiped and its probly got same amount of power as an rb25det but insane tourque on 5psi like rips from 3 to 5grand

[blow thru]

Im running an rb20 standard bottom end standard intake manifold with a gt35r .63 standard cams no cam gears was with a chinesse manifold wolf 3d etc etc running 1.5bar made just on 300rwkw 402 rwhp with water meth for about 6mths an no problems yet.touch wood..no just put on 6 boost manifold..all in the tune