Jump to content
SAU Community

Recommended Posts

HI All ,

my car is a r34 GTT

hopefully you guys will be able to provide some insight to this issue for me.

ok i went to the shops before car started fine with no issues drove fine no issues.

but when i came back from getting some milk unlocked my car , turned the key nothing at all could hear the fuel , no starter motor nosie , no clicks , ticks motor not turning over?

all electronics are working battery is only a week and abit old , i also tried to jump starting it , no luck :)

thought possible my immobilizer was not disengaging , but i was able to push start it with no issues.

able to drive home car was running good. i went to try to start it again after i got home , NO LUCK same thing again turn the key nothing but the electronics and fuel ?

any help or ideas would be great

thank you kurtis

Link to comment
https://www.sau.com.au/forums/topic/242578-starting-issues-r34-gtt/
Share on other sites

A common problem amongst old car's is that the starter motor doesnt work when engine is hot.

"he heat generated in the starter by the engine and the exhaust pipes (sometimes) causes the armature to expand. If the bearings are worn then the armature drags (actually contacts) on the stator causing a short circuit and a high friction drag. Sometimes just replacing the bearings can fix the problem. "

Although your car is quite new, im having doubts that it could be the starter motor?

See if the problem only occurs once the engine is hot? Best to take down to an auto electrician and ask for a free alternator/starter motor/battery check-up. :ninja:

  • 10 years later...
  On 30/10/2008 at 12:22 PM, KURTIS34 said:

HI All ,

my car is a r34 GTT

hopefully you guys will be able to provide some insight to this issue for me.

ok i went to the shops before car started fine with no issues drove fine no issues.

but when i came back from getting some milk unlocked my car , turned the key nothing at all could hear the fuel , no starter motor nosie , no clicks , ticks motor not turning over?

all electronics are working battery is only a week and abit old , i also tried to jump starting it , no luck :)

thought possible my immobilizer was not disengaging , but i was able to push start it with no issues.

able to drive home car was running good. i went to try to start it again after i got home , NO LUCK same thing again turn the key nothing but the electronics and fuel ?

any help or ideas would be great

thank you kurtis

Expand  

Was this ever resolved? I am having the exact same issue in my r34 gt right now.. I drove it perfect this morning to the shops. Got back in and nothing when I turned the key. 

Try to start it with a 50c piece direct onto the solenoid terminal from the main cable (at the starter motor itself).  If it will crank there, then you have a problem with wiring between there and the ignition switch.  If it won't, give it a whack with a soft face hammer or a lump of wood and see if it will crank after that.  If it will, then the solenoid is sticky, which probably means full of clutch dust, but it could just be warm.  Finally, they can get grumpy when hot, when they get old.  If it works when it cools down, then there's your answer.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • There's a huge reason manufacturers are tuning in dead flat torque curves... Make them reliable (and more drive able)
    • What HVAC actuator is under the steering wheel? Do you mean on the RHS of the centre console, immediately to the left of your shin? If so, then yes, it is probably that one, because that is the mode door actuator, and from what I know, it's still a pain in the arse to replace. I don't know about whole dash out, but you certainly have to rip into the centre console section. I don't know if it's covered in the workshop manual, as I haven't spent much time looking at those parts of it. (and by "the workshop manual, I mean the R32 GTR one, which is the most comprehensive one we have, and it should be similar enough between that and later cars to serve as a guide).
    • ...oops. forgot the TCU end...
    • No I got mine from a friend that had fabricated one … but I had to fit it to my setup which was a hks turbo setup. His was a Garrett -7. So one of my turbos was not a flange for one side … then I had a leak in the welds I had to find a weld shut … in the end the setup was decent priced but I spent a lot to get it fitted. A couple companies I checked would make it but you’re talking 7-9k aud with titanium. No joke mine was 6-7k even second hand after I had to fit it in Hong Kong … labour is expensive here. 
    • I'd just like to restate that I don't think anyone here is actually hating I recently sold a car part to a guy who was building a forged auto R34, with MV stall and aiming at ~450kw. I told him that I'm him, from the future and to stop after it explodes once. I told him I knew he won't listen the first time, and that's fine. But if my predictions do come true - Change direction faster than I did. I also said it's probably no coincidence that the dyno plot of a reliable turbo engine starts to look a lot like a N/A motor. :p
×
×
  • Create New...