R33 Type M front bar plastic welding (cut middle out)

[Ronin 09]

Hey people, a question for those of you who have modified a type m front bar for a FMIC -

who did the plastic welding for you (to fix the sides of the bar in the middle cut-out) and what did it cost? I'm in the inner east if that helps, but any pricing info is good...

and, how much would i look at to get the front bar resprayed after?

Cheers ronin

[pushead]

u talking about the bar which holds the number plate rite?

[benm]

Im from Western Sydney and looking at getting the above done when I get my 400R kit painted/fitted.

Got a quote of $500 for....

* Cut number plate section and patch side

* Mesh bottom of front bar

* Re-align FMIC (its about 1 inch to the left)

* Fit UAS air filter box over my HKS Pod

* Connect ducting from that box down to the front bar

* Respray entire front M-Spec bar.

[Ronin 09]

pushead, yep thats the one

benm that sounds good, keep the replies coming - if anyone has a specific place they've used to plastic weld the bugger in melb that would be even better

[Guest RedLineGTR]

PM "Al" hes tha man to talk to

[DJ_L3ThAL]

i cut my mspec bar up for my large cooler im going to get a new fornt bar soon so if your intereste din a cheap pre-cut bar your welcome to take it off my hands

[Ronin 09]

nath i thought you already bought a new bar?

[DJ_L3ThAL]

nah not yet, im either getting a bomex or a garage impul

[Guest RedLineGTR]

u know u wanna get a custom one..

[pushead]

i dont think you will need a whole front respray.. i mean just cut the middle bar (which holds the plate) and grab a can of D.I.Y paint and spray out the cut out area ? kinda dodgie but heyy. youll save big $$$$

[Ronin 09]

my front bar is *cough* a bit worse for wear from driveway approaches (particularly my own drive - the old man has a 911 and every morning i hear is scraping... oh the pain!). i'm going to get the whole bar redone, at the same time get a stealth wing swapped over

[JET-33]

i was gonna go get a quote last week to cut my front bar and mesh up the crappy plastic bits....

seems like every1 is headin that direction...

[Ronin 09]

because its cheap!

[akeenan]

hahha: jet trying so hard to have his car looking different to other peoples :D ....

ronin 09 why not fix the angle of your drive? sounds like it could be cheaper in the long run

[Ronin 09]

haha... thats not a bad idea, but i just can't be bothered... i haven't as yet cracked the current front bar, but it has no paint on the bottom

Means i can't lower it either for the time being

[DJ_L3ThAL]

buy my front bar cheap i tell ya

[Ronin 09]

might just do that... has it been plastic welded?

[boosted gtst]

yo dj l3thal how much are you selling your front bar for.i have one 400r one just like benr32.want to swap or sell for type m one. pm me or email [email protected]

[ylwgtr2]

sam at onduty panels for fantastic paint work and plastic welding 93142647

[Ronin 09]

ylwgtr2, where are they located?