Jump to content
SAU Community

Recommended Posts

hey guys just put new split fire coil packs in my car and my mate did a compression test on my r25det s2 while he was at it

it got 150 - 150 - 150 - 150 - 100 - 150 - 150

he put oil in the bore and it went up to like 130-140 he said.

He is saying its probably the rings, but best to take it to a shop to find out.

what are my options? how much would it be for a mechanic to rip my engine apart find the problem and fix it?

budget is fairly limited, cheapest safe option here is what im looking for that will fix the problem.

any help / suggestions appreciated

Link to comment
https://www.sau.com.au/forums/topic/245868-low-compression-woes/
Share on other sites

id be checking it out definatly, its only gona get worse, all other cylinders read 150psi, and that one is 100. there should be only 10 percent variance between then in any case...

id be rebuilding it as its obviously not healthy. sorry to inform u mate...

The harder you push it, the worse it will get, you will end up with a massive blow by machine...

do a leakdown test as it could possibly be a bent valve or a head gasket problem... i think its not due to the comp bumping up with the oil test

Edited by den001

Out a little bit of oil down the spark plug hole and run the test again.

If it comes up with 150, its your rings.

Oh. hahaha.. sorry.. I should start reading threads.

Yes. Rings it is

Edited by GTS4WD

Yeah as said above, cheapest option if you don't want to rebuild it is to just buy another engine and then sell off your old one. If you can do the job yourself with mates over a weekend (it aint that hard), it will probably only end up costing you $1000 once you part of the old one.

We did it to my mates a month or so back.

where can you pick up replacement engines for that price? sounds good.. im just getting my engine tuned and gonna drive it til it doesnt wanna be driven i think -_-

i wouldnt mate, it will get so bad it will start to missfire badly, after this if u give it a good flog you risk blowing the oil up thru the breathers and leaving the sump with f**k all, it will spin a bearing and they you will be up for even more cash to fix it...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Dredgggggeeee time; I have recently finally started driving the car. It sat for so long that the fuel tank gave birth to rust sludge and blocked my lift pump sock and one of my walbro 460's and left grime, rust chunks and muck all through the surge tank and system. I decided to commit and pull the trigger on an oem r32 gtr fuel tank and Frenchys twin 460 / sender / surge tank hanger combo and all new larger lines and fittings etc, also boost doc heater hose kit / new heater core and a heap of other bits and shits like wideband sensor installed in the dump and Syltech iacv + lines and all wired and added to current tune. now having lightly driven it a couple times without issue, I can happily report on the hta3076 in its current tune. still no boost control switched on, 20psi gate springs, car makes 22psi at 3200rpm in 6th gear with 30-50% TPS from cruise at 100kmh. Going by the old graph, this means it should be making 300-325whp at the same numbers above. Very very responsive setup under true road driving loads. all that's left for the build is body loom + PDM, finish the remote aircon setup, install carbon fibre parts and go for full tune and 30psi. the 315 rear tyres are now performing like they're 195's, wheel spin in any gear at almost any rpm, whereas my previous setup hooked up in 3rd no issue, albeit Nt01's back then / RB25 5spd vs (new) old date r888r's Z34 6spd now, + obviously all the support upgrades I listed in the quoted post above. car sits at 1-3psi on cruise at 100kmh, expectations totally exceeded and I'm beyond stoked with all this so far. IMG_4848.mov
    • I've also been eyeing their rear axles for my car. I purchased seat mounts from them about 7 years ago and they were hot garbage so I've been a little wary about purchasing them. With that being said, please buy them and get back to us haha. 
    • Can a moderator please move this into the right category.. I've accidently put this into racing build thread 🤦🏽‍♂️
    • Being a manual, we very quickly ordered new R34 gearbox (From Nissan) and remaining parts from Kudos motorsports. Would highly recommend the team there. Ultra helpful and quick to share advice and upgrades. We are in the middle of taking the Auto out (Genuine 94,000/kms) and putting the Manual in this weekend. Part 2 of the build will include likely a Plazaman Intercooler and Plenium, Hks Exhaust with Tomei Dump (ordered).
×
×
  • Create New...