Jump to content
SAU Community

Recommended Posts

I got a stock R33 s2 it has the side mount intercooler and i just recieved my http://cgi.ebay.com.au/Turbotech-manual-tu...A1%7C240%3A1308 wat is a safe level above stock that i can put my turbo too? also does any1 know how to install this thing? :) i'm noob :(

Edited by J4M3S
Link to comment
https://www.sau.com.au/forums/topic/246506-how-high-is-safe/
Share on other sites

I ran at 14 psi with no problems but then it wasnt at WOT for to long, ((Ive swapped it out now for a TO4 with a 68 rear (WHICH IS STILL TO BLOODY LAGGY)) and upon inspection the bearings were still ok.

But in the end i must add how has the car been maintained (oils), how long will you hold it at full boost (giving it a bit here and there or draging)

If your turbo blows up dont blame me,LOL.

For peice of mind you could always buy a spare in case of a failure, I sold one for $200 i think a while ago so for a cheap power up grade its good value for money.

I ran at 14 psi with no problems but then it wasnt at WOT for to long, ((Ive swapped it out now for a TO4 with a 68 rear (WHICH IS STILL TO BLOODY LAGGY)) and upon inspection the bearings were still ok.

WOT??...T04??? sorry like i said i'm noob i'm still trying to pick up the short hand

WOT = wide open throttle, to4 is just a bigger turbo.

You need a good boost gauge and when you up the boost do it in small increments or you will end up running at 20 psi and it will blow.

Guest
This topic is now closed to further replies.


×
×
  • Create New...