Jump to content
SAU Community

Recommended Posts

just out of curiosity, how long on average do you take to warm up your car?

i take at least one cigarette time to warm up (10mins approx), that is when i see the oil temp needle touches the first white line and my rpm sits around 900.

i feel that it's a little long, and it doesn't help when i'm rushing to school. been considering a remote start too.

comments?

p.s i drive an R33 GTST M-spec

Link to comment
https://www.sau.com.au/forums/topic/24741-warming-up/
Share on other sites

  • Replies 85
  • Created
  • Last Reply

Top Posters In This Topic

Some people advocate waiting a few moments after starting the engine, not to warm the car up (this can be done while moving) but to ensure that the oil pump has been given sufficient time to circluate oil around the upper block/head/cam area.

Personally, I always give my car a minute or two before moving off, then take it easy until the temp has reached normal.

Link to comment
https://www.sau.com.au/forums/topic/24741-warming-up/#findComment-526990
Share on other sites

Guest RedLineGTR

sometimes if i have time i let the car start and while i'm getting ready or grabbing a bite to eat before i go out let it sit thier..maybe 5min-10min dont usally have time to do this anyways. But on a average day start her up..let the oil pressure go fully up to where its meant to be after it starts...maybe pop a cd on. Reverse it out slowly on to the road...then do a couple of laps around a couple of streets around my house...keep it at the lowest revs i can...then head to the main roads to my destination. Letting the gearbox warm up abit and diff etc. I usally take it easy untill my oil pressure is up where it should be. Then increase my rpms... :P

Link to comment
https://www.sau.com.au/forums/topic/24741-warming-up/#findComment-526991
Share on other sites

Yep, with turbo cars it is particularly important to give the oil a few moments to reach the turbos (which are usually high up on the block, thus being one of the last components to be lubricated after ignition)

I think the main point though, it that there isn't anything to be gained by letting your car idle for long periods of time before moving off - the engine will warm up just as quickly when you're moving and standing still isn't doing anything to help the gearbox/transmission oil warm up...

Link to comment
https://www.sau.com.au/forums/topic/24741-warming-up/#findComment-527165
Share on other sites

I generally only have mine running for about 30 seconds or upto a minute, anymore than that is a waste of petrol and time.

Like the other guys said - go easy for the first 5-10 mins of driving but wouldnt personally sit there stationary for that long.

I use my Oil Temp [factory on 34] gauge to work out when I can drive a bit harder :P If the oil temp is cold, you dont wanna drive hard.

Also use your last 5-10mins of driving to cool the car down after a fang, then you only need a short amount of turbo-timer - again I use my Oil temp guage to workout whats needed.

Sorry got a bit carried away, hope all this helps :)

Link to comment
https://www.sau.com.au/forums/topic/24741-warming-up/#findComment-527185
Share on other sites

yeah what nismo said is all true . i usually let it sit particulary on a cold mornin for about 30 seconds , drive it slowly tring to keep the revs under 2000 . then after about 5 mins i look at all my guages especially oil an then go for it but 5mins is generally all u need no need to idle for that long a period , it would be a waste same with cooling if ive been thrashin it all the way home

then the TT takes longer, but if i say drive (normally) for a few mins after then it doesnt take long at all , and i think is better for the engine then rather switching it just off

Link to comment
https://www.sau.com.au/forums/topic/24741-warming-up/#findComment-527191
Share on other sites

crooser just in case u didnt know the g/box turns while the engine is running and the car stationaryas long as u dont have the clutch pedal to the floor , thats the only time the box is not turning .

redline gtir oil starts circulating the minute u start the engine if it didnt u r engine wont last long . i take it easy when i first start the engine though , never any amount of boost until the coolant temp goes to normal , for the oil temp to get to normal it could take up to 30 minutes though and the harder u drive the hoter the oil will get . u dont have to have oil temp to 140 to give it hard on full boost or high rpm though but when it comes to turning it off then u must make sure u cool it down a little like driving with no boost or idling it at home for a 2-3 minutes , that way ur turbo will leve longer .

demon dave the turbo line is always full of oil so as soon as u start the engine u got oil circulating the last to get oil runing are the cams and the valve stems .

nismo 34 thats fine but it usualy takes that long to back out of the drive so as long as u dont have to back up a steep drive ( puting load on the engine ) u can start and back out .

mark r33 sure drive at low rpm say to 3- 3500 but more impotantly dont load u r engine ( high gear and low rpm ) until it warms up . one part of the engine that doesnt get lubricated when u first start is the cil bore thats when most of the wear happens when u first start it ( the first 30 - 60 seconds )

even if i've been driving along heavy traffic when i stop the car i always idle the engine for a few seconds before turning off .

Link to comment
https://www.sau.com.au/forums/topic/24741-warming-up/#findComment-527425
Share on other sites

I personally warm the car up until the temp needle starts to move then I take off and drive carefully until the temp needle is at normal operating temperature.

I know most would think it's a waste of time to sit there for 10 minutes waiting for the car to warm up, but it's just one of those things I do to look after my car as much as I can. (not saying you people don't look after your cars).

I also adjust my turbotimer to the approriate amount of time for the drive I just did. (don't know why I added that :-) )

my two cents worth anyways...

Link to comment
https://www.sau.com.au/forums/topic/24741-warming-up/#findComment-527463
Share on other sites

its a waste of time and fuel to warm cars up before driving.....u just have to take it easy , i.e dont load the engine or drive at high revs until oil temp is at operating temp, which is about 30 mins into driving...

then you can let loose...:D

Link to comment
https://www.sau.com.au/forums/topic/24741-warming-up/#findComment-527519
Share on other sites

Guest RedLineGTR

personally if i had the time i would let it idle after startup for 5min max and then drive off slowly...but still knowing that there is some heat already in it.

Basically...drive it soft untill desired temp is reached.

Use a good quality oil and a specific rating for cold starts.

Dont push your car untill its ready...unless u want to waste money.

Link to comment
https://www.sau.com.au/forums/topic/24741-warming-up/#findComment-527534
Share on other sites

geez i question the credibility of some of these responses...

how can anyone justify starting and driving immediately? its physically impossible for oil to magically jump from the sump to the top of the engine as soon as you start. there has to be a period of wear unless oil can reach it.

surely there is advantage in leaving you car running for 1-2mins just to move some oil around then drive slowly as said previously...

and if you worry about fuel consumption then

1) you're a pov

2) the way you drive determines your fuel usage not warming up / cooling down. the amount of fuel used at warm up is negligable...

...and the sensor for oil temp is located down near the sump so that is not always the best indication of oil movment (my oil pressure rises very quickly after starting)

but this is only my 2c and you can do what you like...

Link to comment
https://www.sau.com.au/forums/topic/24741-warming-up/#findComment-527845
Share on other sites

oil starts circulating immediately when the engine starts....although very briefly(seconds) you get no/low oil pressure after starting...thats when the damage occurs and no matter how long you warm the engine, this will happen every time you start your engine....why do think taxi's get such long engine life??? coz they rarely stop their engine during their shifts...

secondly there is waste of fuel if you let your car sit there for ten minutes to warm up everyday particularly because the engine will warm up quicker if you are driving it in that ten minutes.....not only will you waste time(precious for some of us) also waste fuel because of the longer standing warm up period and as the engine runs richer during warm up , it will emit more unburnt fuel to the atmoshere which is bad for the environment...

so not only you are wasting your time and money, but also you are exhausting the fuel supplies and adding to the pollution.. :)

Link to comment
https://www.sau.com.au/forums/topic/24741-warming-up/#findComment-527988
Share on other sites

thanks guys for the enthusiastic replies, i do appreciate them, i think i'd take less time to warm up my car from now on, but i still feel that starting the car and driving off is going to do mechanical harm. don't forget, it's a 10 year old car, and it's winter.

maybe i'll time the warm up a little under 5mins. and keep my turbo timer on for 1-2mins after the first start up.

cheers! and happy driving!

Link to comment
https://www.sau.com.au/forums/topic/24741-warming-up/#findComment-528065
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Yeah its bad eh. Ey! Watch your mouth. Yep, spot on. The rear's are always gone too though from brake checking. I had them perilously close to a tree that we had taken down. I think the tree peeps may have taken it. Either for a trophy, or accidentally.  
    • f**kin' yikes! That insulation is the shittest stuff I have ever seen. You need to do an insurance job on that f**ker, pronto. WRT to the washer cover, I would have said that there'd have to be some at a wrecker, then remembered that it's a BMW, and reasoned that every single wrecked one would have been tailgating and so the front end would be trashed.
    • Oh and I lost my headlight washer jet cover!
    • Ok, so I got myself some X1 wheels really cheap to try out, they're a bit different and I like them but they're really narrow (18x8) they are available in staggered 18x8/9 also but really hard to find.  I kinda dig them, but not as much as the F10 19's I usually run, so these go into the wheel pile.         As I mentioned in another thread, I got a new exhaust. It's an off-the-shelf stainless one that fits OH-KAY. I don't love the tips size and how far they come out the back, I think I might cut the tips off and replace with some smaller (~3") ones that don't extend as far. It sounds really good though, I'm not sure if its just in my head but the car feels a little quicker, more responsive.      I fitted an eBay special front lip. Surprisingly it fit perfectly and all holes lined up. Its a little rickety but I haven't put any double sided tape on yet, I want to clean the front bar up where it has scraped the road a lot and fil in the number plate holes (or, get body coloured wrap to cover them - is this a thing?  I'm not sure if I'll leave it gloss or pain it matte. I really like it though, I don't particularly like the front bar without it, I don't really like the M-Sport and to get anything else is just too expensive. That said, I might need a new one now anyway as I dropped the car onto the jack after forgetting to put ramps under the front wheels. It bent a lot and while it did go back to normal after I got the car off the jack, I do fear I have not done it any favours.    Lastly, my headlights died. Different problems in each. They have gotten much dimmer over the past year or so, I put new (uber expensive) OSRAM bulbs in them but to no avail. One of them pointed at the ground and the other just kinda did its own thing with light working sometimes. Yeah, check this 18 year old BMW headlight wire. I reckon I know why they were stuffed.            BTW, the yellow and black is the power to the Xenons. Yikes. I hunted around an researched my options here. I would have loved to just get a replacement harness but not a thing. My car has adaptive headlights, that is they rotate left and right with the steering wheel. Good condition used adaptive xenons were over $700 each, non adaptive were around $400 each, but I couldn't help but think that they're all around 18 years old now, surely they'd have the same problems. So I looked at newer LCI headlights but they were even more expensive and I couldn't confirm that they'd be plug and play with lots of people having lots of opinions so not worth the risk.  I ended up getting brand new Chinese headlights from MARS. They're very close to OEM with only the angel eyes being a bit different. I didnt want crazy turn signals or sharp DRL's or anything. Not my bag.  They're not adaptive, I thought thats a feature I wouldn't really miss. So I coded that out.  The lights are awesome, they look so nice and they take so many years off the car. The angel eyes look great and the headlight brightness is ridiculous. I was so used to the old ones, I didn't realise just how bad they were. The new ones use the OEM bulbs, Xenon ballast and leveller motor which I was happier with. The only issue with them is that the rear cover is held on by SEVEN screws. This will be a nightmare to get to and open when I need to change bulbs.   
    • Now that you mention it I can see those too. More subtle. The lighting and low resolution makes it hard to assess super well what's going on but what is visible is bad enough to pull the motor.
×
×
  • Create New...