Jump to content
SAU Community

Attesa Problem R32 Gtr

phantomgtr
 Share

Recommended Posts

phantomgtr Enthusiast

phantomgtr

Posted
Posted

hey guys i have an issue with my 4wd system and i want to get it working. Since i got the car its been in 2wd mode. I did some reading up and i noticed the tank in the back was empty so i topped it up, the 4wd would work in the air/ on a hoist, but when you drop it the ground it didn't work. I bleed the system from the little nipple under the car and disconnected the bleed connector in the right hand side as well when i did this.

After doing this the 4wd still didnt work and it lights up 4wd and ABS. I found when i took off the bleed connector you could hear the pump whine, and the front torque display 10, when i drove it would drop to 0 and when i gave it a hit, it would increase but not reach 10. When i come to a complete stop it would go to 10 again and you could hear the 4wd pump once again.

When i connect the bleed connector, i am back to square one. So if anyone knows who could help me out, or anyway of helping me that would be great. Thanks.

Link to comment
https://www.sau.com.au/forums/topic/248067-attesa-problem-r32-gtr/
Share on other sites
doo doo Proficient

doo doo

Posted
Posted

Don't leave the white plug disconnected for any length of time or you'll fry the attessa pump. Check the flashing red LED on the attessa computer under the rear parcel shelf as suggested and if you don't have a w/shop manual post up the code it's flashing. It's normal for the front wheels to turn when the car's in the air without the attessa being actuated.

  • 3 years later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • Dose Pipe Sutututu
      What brakes on R34 GTT(Europe)

      By Dose Pipe Sutututu · Posted

      Pads for R32 GTS-t, R32 GT-R non V-Spec (Sumitomo), R33 GTS-t and R34 GT-t are all interchangeable. R34 GT uses a 2x piston caliper, hence it didn't fit.
    • soviet_merlin
      WGNC34 - floor mats

      By soviet_merlin · Posted

      Checked with amayama and nope, the full S2 manual set is not available anymore. Unsurprising, but still disappointing as the ? on availability gave a glimmer of hope.
    • joshuaho96
      Tomei gasket

      By joshuaho96 · Posted

      I've heard the Tomei USA head gaskets are decent if you want to o-ring the heads but otherwise not recommended.
    • GTSBoy
      What brakes on R34 GTT(Europe)

      By GTSBoy · Posted

      The 296mm rotors are the R33 turbo brakes. The 310mm rotors are the R34 turbo brakes. The calipers are nearly the same, but not. They're the same caliper but the R34 caliper has longer legs so that it sits out far enough to go over the rotor. The pads are the same for both. When you say, "I bough tsome EBC"....did you just mean pads? Or rotors? 310mm rotors fit under 17" wheels. There may be some wheels without enough clearance though. I can't fit my fingers between the barrel of my wheel and the "corners" of my R34 calipers, but there is plenty of room behind the spokes. This is on Enkei RPF1. You can fit 324mm rotors inside a 17" wheel, but I'd be willing to bet that it would be close to impossible with the Nissan/Sumitomo caliper (using an adapter, of course), because the Sumitomo caliper is fatter than the Brembo caliper that is supposed to go on the 324mm rotors.
    • Kapr
      What brakes on R34 GTT(Europe)

      By Kapr · Posted

      Hi. Can someone tell me what brakes(and mainly WHERE) can i buy brakes on R34 GTT? I bought some EBC which SHOULD go on my car(i have GT but it has GTT brakes) but it does not fit, Brakes are "too" small(296mm) Are 310mm be good or? I have 17 inch wheel so no "big boys" but for me driving i just need one that fits and i can get here in EU/Czech.
×
×
  • Create New...