Jump to content
SAU Community

Recommended Posts

Hey guys I want to neaten up my interior and have noticed around the HU surround the dash has scuff and scratch marks on it, so instead of going down the expensive path was wondering if there’s anything that can be done as a DIY to repair it??? I believe its plastic so sand back and dye it maybe?

And just to be clear this is part of the dash board that runs along the side of the centre console

ta

Ash

Link to comment
https://www.sau.com.au/forums/topic/249087-dash-scuff-marks-tidy-up/
Share on other sites

ye i saw that also but its not the actual HU. its the part of the tas the runs alon the side. pretty much its part of the dash. ill post up pics tonight will make it easier for explaining lol

f**king sigh

every time i see these marks it just shits me up the wall.

look at how bad they are

16122008050.jpg

previous owner said audio install was done by professionals. thats bs right there. look at all that damage.

i was thinking about wet sanding it with very very very fine sand paper then dye it but ye

that sucks

Damn man i feel your pain i went to a well known audio installer in sydney and got the same outcome!

On top of that previous owner painted or covered my trim with some sort of sticky crap that usually goes in the engine back to make it shiny, and after months now its coming out.

So i grabbed a cloth and thinner, and now gotta remove all this ugly moist cover like thing..

Never knew the audio surround was meant to be grey.

MRXTCZ

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • What can't be done with a little bit of decking board or similar timber bolted to a hub flange via 2 wheel nuts is not worth talking about.
    • I noticed something. On the tps sensor and the sensor behind the adjustment screw is adjusted towards the far left. Are these screws supposed to be centered? (this sensor was in the same position before the tune as well)  Also attached a photo of where my car usually idles at when warm (sometimes a tiny bit above that). I think I might have screwed up the calculation and it might have better than I thought lol at 750rpm still not 650rpm though.      
    • So for both general interest of engine health, and to rule out any coolant/oil issues, I organised an oil analysis done on the 125,000klm oil Results below, all good, just a bit of fuel dilution which I'm not too worried about
    • This is actually a really good way of measuring what wheels fit. If only there was a similar measurement between hub face and suspension :p That said, it's probably pretty simple to actually measure it all with the wheel off the car for the rear. The front is a bit more complex but.. 
    • Being the top Google search result for R34 wheel-related inquiries, lemme throw down my experience. I calculated that 100mm from hub face to wheel face is about the perfect fitment for my ENR34 sedan.  I've been running 18x8.5s, ET35, with a 1" spacer. So, 8.5in to mm = 216mm. 216/2 = 108mm. 108-35 = 73mm. 73+ 25 (1" to mm) = 98mm.  If you wanna get close to this on dif widths, here are the offsets you'll want: 9" - ET around 15mm 9.5" - ET around 20mm 10" - you're crazy, but ET around 30mm All these should fit perfectly on a non-widebody, non-GTR Skyline. Note that it's probably the absolute max, and you're probably better off running a couple degrees of camber in this config, but it looks great, super flush.
×
×
  • Create New...