Jump to content
SAU Community

Be careful on repaired vehicles offered for sale out of Japan.

Guest

By Guest,
in General Automotive Discussion

 Share

Recommended Posts

Guest

Guest

Posted
Posted

Be carefull as some people are offering repaired modern cars for sale out of Japan as they are cheap but may end up costing you your car.

The rule is below so read into it dont take somebodys word for it.

A RAW would take all reasonable steps to avoid importing a crash damaged or corroded vehicle.

A RAW wont put up his bussiness to save you money.

In a nut shell they are saying dont bring in a damaged or repaired vehicle. I know of one complyier who knocked back a car as they were told by the importer it is a repaired vehicle but only minor damage. They knocked back the work and said unless you are 100% sure it is minor it will be at your cost. So the buyier went back to the broker who wouldnt sign a document that the car will pass the RAWS inspection then the importer went a bougt a straight as car to save the trouble.

Damaged Vehicles

Crash damage or corrosion may affect continued compliance with the ADRs. This is especially so in the case of the occupant protection ADRs 69, 72 and 73. It is not possible for a RAW to provide a reasonable level of assurance that a crash damaged or corroded vehicle, where the structural integrity of the vehicle has been affected, complies with all of the applicable ADRs. Therefore, it is not permissible for a RAW to fit a used import plate to such a vehicle.

Before commencing compliance work each vehicle must be inspected by the RAW to check for crash damage, damage repair or corrosion that may affect the structural integrity of the vehicle. Records of this inspection are to be retained by the RAW and be made available to VSS inspectors upon request. (Regulation 57)

Crash damaged or corroded vehicles where the structural integrity may be affected must be re-exported or destroyed. It is expected that a RAW would take all reasonable steps to avoid importing a crash damaged or corroded vehicle.

The criteria below must be used as a minimum when deciding if crash damage or corrosion is likely to affect the structural integrity of the vehicle.

q Underbody damage which results in the:

Ø crushing of floorpan stiffening members,

Ø splitting of seam welds or

Ø tearing of the metal

q Damage to rocker panels (or outer sill) which result in:

Ø Dents to a depth of more than 25 mm

Ø Creasing, distortion of the sill weld

q Distortion to longitudinal rails affecting the front and rear crush zones.

q Collision damage to steering or suspension components.

q Damage to the vehicle’s outer body panels, which affect the integrity of any of the seams or joints installed by the vehicle manufacturer.

q Corrosion (rust) which has resulted in perforation or flaking of the metal.

When checking the condition of the vehicle the following items need to be inspected but not necessarily in this order:

q Engine compartment

q Right side

q Luggage cargo compartment

q Left side

q Underbody or chassis frame

q Passenger compartment

Guest

Guest

Posted
Posted

I will always drive a import, Soarer loved it, 180 now that car is fun and RX7 sitting in showroom waiting for me to sell 180.

It is worth it and take advice from people that have nothing to do with the people you are buying off and dont rush.

I have personaly seen a couple of importers telling the truth to buyiers knowing that they wont sell a car to them, they just want to tell the truth, they have a heart beat.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing


  • Latest Posts

    • DraftySquash
      Help Understand GTT Boost Setup

      By DraftySquash · Posted

      Me, if I ever floor the car
    • Kinkstaah
      Help Understand GTT Boost Setup

      By Kinkstaah · Posted

      You have the option to do this. Nobody but me ever did this (go slower, I mean) Everyone seems to fall victim to "This would be a great setup for you, but for me, I need a little more power..."
    • joshuaho96
      Help Understand GTT Boost Setup

      By joshuaho96 · Posted

      Save yourself the headache of an alarm. Immobilizer on the signal side of the main EFI relays so it won't start is good enough. DIY killswitch is the same thing except instead of a nice passive system you need to remember to switch it on and off.
    • GTSBoy
      Help Understand GTT Boost Setup

      By GTSBoy · Posted

      Yeah, the advent of canbus was supposed to cut down on wiring weight, then some bright marketing wonk says "oh, look at all these wonderful tech gadgets we can cram in here now that we have this wonderous technology" and some arsehole safety legislator says "oh, look at all the wonderful surveillance and tracking gadgets we can cram in here now that we have this wonderous technology" and some dipshit young engineer who has grown up thinking that an extra 500000 lines of code is not a problem because storage is cheap these days says "oh look at all this wonderful shit I can do to one up those dipshit arsholes over at VW" and the Karens of the world all go "oh look at all these fancy things I can do on my screen (so long as I am not driving on a bumpy road wherein touch screens immediately become the single most stupid shit idea ever shoveled into a car) and my 19 zone airconditioning keeps my sweaty fat folds a bit less damp and the windows close themselves because I'm too fat and lazy to wind them up for myself and these reversing sensors would have been great if I'd paid attention to them instead of smashing them on the bollard while I was reversing and staring fixedly forward that day I went to pick up little Charlize from ballet" and the sweaty mongoloids who say "oh this wonderful collision avoidance technology with these 45 excellent radar antennae scattered across the front of my car mean I can tailgate like a methed up tradie at full speed with no fear because the car and the 35 airbags will protect me if it all goes wrong" ...... </shallistopranting?>
    • Dose Pipe Sutututu
      Help Understand GTT Boost Setup

      By Dose Pipe Sutututu · Posted

      There's a post from a member (can't recall who), went down the path of a twin scroll G30-660 and it's doing over 300kW+ AND comes on about the same as a high flow RB25DET turbo. Have your cake and eat it too in this case. TBH, if I had a 2nd chance of building my car again (i.e. someone gave me what I wanted for my shit box, but the deal was I had to re-build another R33 and keep the change) I would just pop in a stock NEO motor (with new seals, rod bearings, ARP studs, head gasket, sump, Nitto pump), get a smaller twin scroll turbo, modify the stock low mount (keep the divider in place), and make a solid 300kW on 98RON and call it a day. 
×
×
  • Create New...