Jump to content
SAU Community

Recommended Posts

I bought them for last year as I was doing ridiculous kays in my car. In short, no. They're not very good. They tend to wear reasonably well but if you want a performance tyre, look elsewhere.

They do smoke up quite well though :D

230703JPM_030.jpg

Adrian

Link to comment
https://www.sau.com.au/forums/topic/24979-falken-ze326/#findComment-530959
Share on other sites

I'm on my second set, and I only replaced the first because I was concerned how they would go in a RWC.

I've got good mileage out of them (20k+), including some time on the race track (club sprints only). They don't like being caned (as on the track), but as a general on-road high performance tyre, I've yet to fault them.

They're probably not as good overall as Bridgie 520s or whatever those Bridgies are on the HSVs, but those Bridgies are not twice as good (I think they cost about twice as much).

A good bang-for-your-buck performance tyre, IMHO.

Link to comment
https://www.sau.com.au/forums/topic/24979-falken-ze326/#findComment-531225
Share on other sites

i have falken ze502's on the rear of mine. they have some nice grip, but wear quite quickly - ive only gotten 10,000k's outa mine :) and they cost 320 each aswell :)

back to topic : i havent heard anything about these tyres gloof

Link to comment
https://www.sau.com.au/forums/topic/24979-falken-ze326/#findComment-531408
Share on other sites

That's cheap for ZE-326. I remember when I got mine they were like $180. For the price you pay for them, they are pretty good. As everyone said, not much grip when launching but alright for just street tyres.

The good thing is that these tyres are none directional so I can swap my tyres without been refited when it start wearing out on the inside shoulder. Hasn't happen yet but on my old tyres my front were wearing on the inside shoulder.

Link to comment
https://www.sau.com.au/forums/topic/24979-falken-ze326/#findComment-537144
Share on other sites

The good thing is that these tyres are none directional so I can swap my tyres without been refited when it start wearing out on the inside shoulder.

You will still have to refit them. Otherwise, if you just swap the wheels, you'll have the tyre on the other side of the car, turning the other way, but still wearing the inside. :burnout:

Link to comment
https://www.sau.com.au/forums/topic/24979-falken-ze326/#findComment-539638
Share on other sites

Yeah that's what I mean swaping wheels altogether, so would be inside out with the wore shoulder outside and the better shoulder inside. This would balance it out abit. And when the inside start wearing again, i'll swap it again hehehe.

Don't know how many time I'll be able to swap them around for haha.

Link to comment
https://www.sau.com.au/forums/topic/24979-falken-ze326/#findComment-541579
Share on other sites

They're reasonable all around tyres for the price.. So if that is what you're after, go for it. If you're doing heaps of burnouts or mucking around probably going to be fine for that.

Meant to have greater life than the ze502's, but less grip. Nothing terrible, but they only gave me a bit more traction than my old Simex I think :D

Personally, while i bought those tyres due to recommendations on here - i'd try something different. They are cheap though :(

Link to comment
https://www.sau.com.au/forums/topic/24979-falken-ze326/#findComment-545975
Share on other sites

Hi, I've got some Falken ZE -502(205/55/16) on My R32 gts4 had them since April

got them from quickfit for $600 for set fit&bal. They are ok, but squeal easier then than the BFGoodrich radial TA's i had before.

The Falkens are better steering tires than the goodriches but have less traction than goodriches on the rears.i.e. going around small roundabouts in the wet, falkens hold line, goodriches run wide-understeer! like crazy.

Link to comment
https://www.sau.com.au/forums/topic/24979-falken-ze326/#findComment-550110
Share on other sites

What speed rating are the ST115? I had a look at the American site and some seemed to be V or W rated, but most had no speed rating listed at all. And what does Treadwear 360, Traction A, and Temperature A mean?

Link to comment
https://www.sau.com.au/forums/topic/24979-falken-ze326/#findComment-550670
Share on other sites

well, treadwear is a comparative number for how long the tyre will last, not sure about what the scale is tho. traction and temperature I'm not sure about

.....it would be great if we could get a tyre expert on these forums :)

Link to comment
https://www.sau.com.au/forums/topic/24979-falken-ze326/#findComment-556118
Share on other sites

I think the ST115's are softer than the ZE326's, which would mean that the higher the number, the softer it is? My girlfriend's Nankang EX601's have a treadwear of 320, and they last a pretty long time. I can't imagine the ST115's lasting any longer than that.

Link to comment
https://www.sau.com.au/forums/topic/24979-falken-ze326/#findComment-556280
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Latest Posts

    • Sorry I think that must be another language thing, globe = light bulb
    • Man, you guys are like an all knowing encyclopedia.. how do you guys know how to fix everything?? but thanks. i will try to trace this wiring today. What is this globe thing you are referring too? Globe Power Supply? Are you referring to the light bulb?
    • Vinyl paint always ends up coming off interior trim and looking like arse. For the a pillar trims.....just try cleaning them with fabric shampoo? Maybe ditto for the headliner.
    • Hi everyone, I'm generally new to DIY projects, and I've browsed this forum and watched a lot of youtube videos but still have a few questions   Firstly, how does spray painting interior hold up? in particular like vinyl parts, my current mode of thinking is to use methyl spirits to take off original paint, clean/prep well, light coats, no primer or clear coat    Secondly, what is recommended for the headliner and, for example (my car is a r34), the A-pillars which are some kind of other fabric material, do you think I would be successful at retrimming these? or would it be better to go down the blacking out via Dupli-Color Vinyl & Fabric Paint    Any other advice / tips / tricks for refreshing/modernising these interiors?    Thanks
    • As title says  Pm a photo with what u have  Type m style would be good As Hidding a thick front mount
×
×
  • Create New...