Jump to content
SAU Community

Recommended Posts

Hey guys,

Theres this weird thing that happens to my car at stops/when its idling... it does burst of small revs like 250rpms .. kinda like a cough (the car shakes abit). It happens approx. once every 10 seconds. Should i be worried? or is this normal? thanks

Link to comment
https://www.sau.com.au/forums/topic/249844-strange-problem/
Share on other sites

Worried no, do something about it yes.

Could be the AAC Valve (very common cause of idle issues) clean it and see.

Could be the AFM, clean it and see.

Once those are clean you can try resetting your ECU, which is a good thing to do from time to time anyway.

Could be a small vacuum leak somewhere, worry about the first two in that order before this.

Are there any other issues along the rev range?

You don't have the aircon on when this happens do you?

See how you go and let us know.

Cheers

Link to comment
https://www.sau.com.au/forums/topic/249844-strange-problem/#findComment-4331016
Share on other sites

this started happening to my car not long ago

and now i have a huge problem the car is misfiring. coil packs have just recently been changed too. perhaps my spark plugs are worn i will buy a new set this weekend and test this out. i will also put the old coil packs in one at a time to see if one of the new coils are gone. they are obviously still under warranty but who knows. in the meantime my car is running like complete shit. slow, shaking, sounds like a wrx too.

Link to comment
https://www.sau.com.au/forums/topic/249844-strange-problem/#findComment-4332683
Share on other sites

Drew do some searching around, also try not to hijack this thread lol, but your issue could be one of the ones on my list. Could also be a crank angle sensor.

Test the stuff on the list and see how you go.

Let us know...

Link to comment
https://www.sau.com.au/forums/topic/249844-strange-problem/#findComment-4332688
Share on other sites

Drew do some searching around, also try not to hijack this thread lol, but your issue could be one of the ones on my list. Could also be a crank angle sensor.

Test the stuff on the list and see how you go.

Let us know...

hijack? lol. im telling the guy im experiencing the same problem whats the point in starting a new thread.

in response

iv done a full engine diagnostic test with a laptop. cylinders are fine. for some reason the car is running very lean. i richened the AFR ratios and the missing seems to stop. i also did a fuel pump road test however none of these problems brought back any answers.

next i will put some cheap spark plugs in. if this doesnt fix it (one of the spark plugs could be worn) i will replace each new coil pack with my old coil packs to see if one of my new coils are stuffed.

it is "not" the aac valve this is clean. the AFM is brand new. i also put in another ECU and the same problem occured so its not computer related. it "may" be an air leak somewhere in a gasket. this is where i will look next after the coils and spark plugs.

Link to comment
https://www.sau.com.au/forums/topic/249844-strange-problem/#findComment-4332705
Share on other sites

Hmm, yours is a more curious issue then, most rough idle probs can be solved with the above list but your leaning out implies there's an air leak somewhere. A bad plug would end up with a rich reading as it wouldn't be burning off all the fuel I'd of thought.

Keep us posted mate.

Link to comment
https://www.sau.com.au/forums/topic/249844-strange-problem/#findComment-4332713
Share on other sites

well i seem to have two problems

AAV valve broken. turning idle set screw completely in and out changed nothing. and unplugging connectors doesnt change anything either so its either blown or faulty.

i will clean it out tomorrow to see if it revs a little cleaner

my bov is also leaking somehow. i blocked it off completely and the idle problem stopped.

need to buy a new plumb back or second hand stock one.

problem wasnt spark plugs or coil packs.

Edited by DrewII
Link to comment
https://www.sau.com.au/forums/topic/249844-strange-problem/#findComment-4337024
Share on other sites

Tested the problem with air conditioning on/off, i dont think it effects the frequency of the "burst of revs". Only seems to happen on idle.

My R33 is an NA (think this should cancel any issues relating to turbos). Ermm, got the spark plugs changed not too long ago, should not be the problm. Havent quite got arround to cleaning the AAC valve yet tho. Anyway, GL DrewII u seem to have a real problem there.

Link to comment
https://www.sau.com.au/forums/topic/249844-strange-problem/#findComment-4337471
Share on other sites

i have cleaned my AAC valve out

it was very filthy. the DIY AAC Valve guide in the DIY section was extremely easy to do.

the car is still sounding like a WRX so i can't tell completely what cleaning the valve has done. would have done more good than bad.

however im getting a brand new GFB Plumback bov installed so i will let you guys know an update after the new valve has been put on.

my problem is 90% bov 10% AAC valve so i should be sweet after the new bov is put on. fingers crossed.

Link to comment
https://www.sau.com.au/forums/topic/249844-strange-problem/#findComment-4339042
Share on other sites

its a normal skyline thing..u'll get use to it...

ive also got atmo greddy adjustable bov..and a atmo bov WOULD cause bad idle...

mine is set-up to hard setting..to prevent roughish idle...

the last thing u can do is take off ur idle air control valve..

spray it down wit carby/throttle-body cleaner..wipe off all the carbon..

and put it back on..

also adjust the screw on the side..will adjust ur idle..either up or down...so yeah...

just letting u no :P

Link to comment
https://www.sau.com.au/forums/topic/249844-strange-problem/#findComment-4346293
Share on other sites

its been happening to me also, my car after warmed up ussually idles at approx. 600 - 800rpm, then after sitting there for about 5 - 10mins, drops to 450 - 500rpms for a few seconds at that time the car shakes abit aswell.... HELP??

Hey guys,

Theres this weird thing that happens to my car at stops/when its idling... it does burst of small revs like 250rpms .. kinda like a cough (the car shakes abit). It happens approx. once every 10 seconds. Should i be worried? or is this normal? thanks

Link to comment
https://www.sau.com.au/forums/topic/249844-strange-problem/#findComment-4351111
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Yes...but look at the numbers. There is a tiny tiny fraction of the number of Joules available, compared to what is used/needed. Just because things are "possible" doesn't make them meaningful.
    • Thanks for taking the time to post that ! If anything changes or happens please do update us. 
    • Somehow Vertimass/Oak Ridge National Labs has figured out a catalyst that can convert ethanol into C9-C10 hydrocarbons in basically a single step without ending up with a bunch of ethylene or similar waste products: https://patents.google.com/patent/WO2023224867A1/en I still don't think anything like this will keep us from needing to transition to EVs regardless along with all kinds of other electrification, but things like this will go a long way towards alleviating the problem of how to electrify things like planes. Renewable diesel is seemingly an easier problem as well, Chevron is already running refineries for the stuff and the primary feedstock is tallow and other waste fats from agriculture.
    • Ok so I have sorted everything with my uniclutch and  i can offer up a bit of feedback and some things that might help others.    I found problems with factory damper line. Weird shit and had trouble with peddle adjustment    I used this https://au.gktech.com/products/r33-gts-t-skyline-braided-clutch-line?_pos=2&_sid=22b01b9b9&_ss=r Also when adjusting peddle leave a bit of play. You can get into a over stroke condition easy.. Make sure you can push the slave forward after adjusting to confirm fluid can return to master then you will need to pump it up heaps…..not sure why but that’s how it is.    last thing the splined adapter is machined perfectly. If your input shaft is old like mine was I would put a bit of valve grinding paste on it and stroke it like a 15 year old. Just to give it a tad more clearance and to better match it to the spline.    reason is on a near flat shift I have had situation where the peddle returns a millisecond after you lift from the clutch. No slip or anything but I reckon this is due to tolerance on the spline being way tighter than stock clutch and binding for a sec. I think this will go away but also my spline was old. Box is old so I guess I should have checked better. It’s a super neat fit.    it feels light as and holds awesome without any noise    
    • My Fuga Hybrid is JDM, 2014 model but very similar to the V37 from the looks of things..same platform just physically larger and very comfortab;e
×
×
  • Create New...