Hbow To Remove Rounded Wheel Nuts Help!@!

[vice5500]

I have 9 fully rounded off wheel nuts that i cant remove, they are resessed into the mag so either drilling out studs or using a female easy out will work but i dont know where to find one or where to buy one from any help ?

[JMW]

Have you tried using a smaller socket and bashing it over the nut with a hammer? Might just be enough to loosen them.

[GTR-N1]

Is this on the Dodgy-VIN-plated R34 GT-T you bought in November?

Under "Importing Vehicles" eh?

[tridentt150v]

cold chisel

[julz2bit]

Have you tried using a smaller socket and bashing it over the nut with a hammer? Might just be enough to loosen them.

Yep this is the only way that is simple. Use a smaller socket than the wheel nut and hammer it on the wheelnut and undo. or find a snap on truck and they will sell you a tool to get them off. but will cost a arm and a leg, but will last forever.

[MYRB30]

Weld a nut on to them then undo them

[tridentt150v]

^^^^ he said they were recessed in too deep....otherwise I'd agree.

A really good welder might be able to weld on a tube, use a stick welder and weld down the tube inner, then weld a nut on the end of the tube. It's not something I've had to do, and not sure I could, but I'd give it a go if I was stuck.

[BLKR34GTT]

yeh i'd say a smaller socket and bashing it over the nut with a hammer or a chisel too