Jump to content
SAU Community

Z-tune?


nisskid
 Share

Recommended Posts

I like it with the vent in the door. Would be good if that flowed lots of cool air over the transmission and aftermarket coolers in the rear of the car. Having in the rear quarter panel ruins the lines majorly

nice photoshop work though guys

Link to comment
Share on other sites

haha this just keeps getting better! love the last one, but why don't you guys start from scratch instead of using nisskid's as a base...

i dont mind people using mine, its good to get some ideas, but yeh some original ones would be good.

Link to comment
Share on other sites

i dont mind people using mine, its good to get some ideas, but yeh some original ones would be good.

The reason i did was that it was convenient and a good base to build from

not sure on those headlight covers on that last one :P

agreed, looks pretty good though

Link to comment
Share on other sites

  • 5 weeks later...

Close enough :devil:

In fairness to myself, rumour has it that a few extras were retro-built (at enormous expense to the owners who requested them) after the initial batch too, so I may be more correct that you think :D

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share



  • Similar Content

  • Latest Posts

    • Much less twat-tastic. CF wheels are too garish for civilised use.
    • From there, as the manual says....assembly is the reverse of disassembly, no tricks worth mentioning Much better (for me)
    • In my case, the standard wheel I had was in good condition but the buttons had more wear, so I swapped them across from the original wheel from the car. The plastic rear cover is held on by 4 tabs, and once the wiring is removed you can get access to 2 screws on each side the hold the buttons in From there I just swapped the wiring over. What was interesting is the standard style wheel is 2.0kg but the carbon fibre one is 50% heavier at 2.9kg. It even has a weight inside the wheel at the top to make up for some sort of imbalance in the design. weird
    • Once the airbag is off, to remove the steering wheel.... Undo the 2 plugs into the clock spring, and the horn connector from it's clip. Hit the 19mm nut with a rattle gun (preferably) or if you don't' have one, you probably want an assistant to hold the wheel in place while you use a breaker bar to undo the nut Then, screw the nut back on 3 turns, and pull the wheel sharply towards you. If that doesn't work hit it medium force with a rubber mallet on either side, or possible behind if you can get there. If that all fails (it shouldn't!) you might need a steering wheel puller
    • So, to next task....the carbon fibre steering wheel was either an expensive factory option or a chinesium special. Either way, I don't like either the flat bottom or thick ring style, so it had to go So...to remove the steering wheel.... First, disconnect battery negative and stomp on the brake pedal for a few seconds. Then, remove the small circular covers on each side of the wheel's rear surround to uncover the airbag clips. You need to push something like a flat bladed screw driver through, to push the steel clip inwards and pull the side of the airbag forward. Once you've done the easy side, same on the centre console side. You can see the tab you are shooting for circled in red Then, disconnect the horn spade connector and for the yellow airbag plug you need to get something small under the black locking tab to pop it out, then the connector releases......airbag is off  
×
×
  • Create New...