Jump to content
SAU Community

Recommended Posts

  • 2 weeks later...
Hey guys just wondering if it's a straight forward swap? The reason for is because it is white with the red needles and that would match the gauges I'm planing on getting.

I'm looking into this too. The circuitry on the back is pretty simple. Here is what I have found so far:

Left side pins:

Oil/Boost Earth

Oil Temp Signal

Boost Signal +

Boost Signal -

Right side pins:

Illumination Earth

Battery Earth

Illumination 12V

Battery 12V

The voltage and illumination is no problem, just tap into the radio loom. But you will need to find GTR sensors for the oil temp and boost.

  • 2 weeks later...
I'm looking into this too. The circuitry on the back is pretty simple. Here is what I have found so far:

Left side pins:

Oil/Boost Earth

Oil Temp Signal

Boost Signal +

Boost Signal -

Right side pins:

Illumination Earth

Battery Earth

Illumination 12V

Battery 12V

The voltage and illumination is no problem, just tap into the radio loom. But you will need to find GTR sensors for the oil temp and boost.

would be an awesome swap... is there any mods needed to do to the dash to fit?

There are differences in the pin configuration for r32 series cars for certain years, try it and see.. I have a late r32 gtr dash in an early r32 gts4. Lots of electrical crap was wrong but it is easy to shift the wiring around in the connector.

There are differences in the pin configuration for r32 series cars for certain years, try it and see.. I have a late r32 gtr dash in an early r32 gts4. Lots of electrical crap was wrong but it is easy to shift the wiring around in the connector.

Cheers guys, have to get hold of a cheap cluster and see what I can come up with.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Pads for R32 GTS-t, R32 GT-R non V-Spec (Sumitomo), R33 GTS-t and R34 GT-t are all interchangeable. R34 GT uses a 2x piston caliper, hence it didn't fit.
    • Checked with amayama and nope, the full S2 manual set is not available anymore. Unsurprising, but still disappointing as the ? on availability gave a glimmer of hope.
    • I've heard the Tomei USA head gaskets are decent if you want to o-ring the heads but otherwise not recommended.
    • The 296mm rotors are the R33 turbo brakes. The 310mm rotors are the R34 turbo brakes. The calipers are nearly the same, but not. They're the same caliper but the R34 caliper has longer legs so that it sits out far enough to go over the rotor. The pads are the same for both. When you say, "I bough tsome EBC"....did you just mean pads? Or rotors? 310mm rotors fit under 17" wheels. There may be some wheels without enough clearance though. I can't fit my fingers between the barrel of my wheel and the "corners" of my R34 calipers, but there is plenty of room behind the spokes. This is on Enkei RPF1. You can fit 324mm rotors inside a 17" wheel, but I'd be willing to bet that it would be close to impossible with the Nissan/Sumitomo caliper (using an adapter, of course), because the Sumitomo caliper is fatter than the Brembo caliper that is supposed to go on the 324mm rotors.
    • Hi. Can someone tell me what brakes(and mainly WHERE) can i buy brakes on R34 GTT? I bought some EBC which SHOULD go on my car(i have GT but it has GTT brakes) but it does not fit, Brakes are "too" small(296mm) Are 310mm be good or? I have 17 inch wheel so no "big boys" but for me driving i just need one that fits and i can get here in EU/Czech.
×
×
  • Create New...